MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0117 on Dodge Durango

Engine Coolant Temperature Sensor 1 Circuit Low

Factory diagnostic protocol and troubleshooting wire for fault code P0117 specifically for the Dodge Durango (2021–2026, 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP)).

Verified OEM Telemetry & Field Repair Tree
Dodge Durango2021–2026
Dodge Durango
SUV3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
Durango SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Not Recommended
High urgency level
Est. Repair Cost
$80 - $250 (DIY: $20 - $60)
Parts & Labor DIY
Check P0117 On Another Dodge Model:
Diagnose P0117 on Specific Durango Model Year:

1. Symptoms of P0117 on Dodge Durango

When the Engine Control Module (ECM/PCM) on your Dodge Durango (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP)) logs fault code P0117, drivers commonly observe:

Check Engine Light on on Dodge Durango (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP))
Radiator radiator fans running constantly at high speed on Dodge Durango (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP))
Temperature gauge pegged at maximum H or not reading on Dodge Durango (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP))
Engine hard starting when cold (flooding from excess fuel) on Dodge Durango (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP))
Poor gas mileage and rough idling on Dodge Durango (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP))
Dodge Durango OBD-II Port Location
The 16-pin diagnostic connector is located Driver lower dash panel near fuse box. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Dodge Durango

Historical warranty claims and technical repair bulletins for Dodge Durango point to the following failure distribution:

55%
ECT sensor internal short to ground (Dodge OEM Part)
25%
Short circuit to ground in ECT signal wiring harness (Dodge OEM Part)
12%
Damaged, corroded, or water-contaminated ECT connector (Dodge OEM Part)
8%
Faulty PCM / ECM analog input circuit (Dodge OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Dodge Durango.

3. Step-by-Step DIY Repair Guide for Dodge Durango

01
Scan ECT Temperature Data

Read ECT live PID on scanner. If it reads 284°F (140°C) or higher with engine cold, a short to ground exists. on the Dodge Durango equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP).

Required Tool: OBD-II Scanner
02
Unplug ECT Sensor Connector

Unplug sensor connector while watching live data. If temperature drops to -40°F (-40°C), the sensor itself is shorted. on the Dodge Durango equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP).

Required Tool: OBD-II Scanner
03
Inspect Wiring Harness

If reading stays pegged at max with sensor unplugged, inspect harness for pinch points grounding against engine block. on the Dodge Durango equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP).

Required Tool: Digital Multimeter
04
Replace Engine Coolant Temperature Sensor

Allow engine to cool, unscrew old ECT sensor from coolant crossover pipe or thermostat housing, install new OEM sensor with fresh thread sealant. on the Dodge Durango equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP).

Required Tool: 19mm Deep Socket, Ratchet, Coolant Catch Pan
05
Top off Coolant & Clear Codes

Bleed air from cooling system, clear DTCs, and verify normal temperature rise on live data. on the Dodge Durango equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP).

Required Tool: Coolant Funnel Kit, OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Dodge Durango (P0117)

Prime Fast Delivery & Verified Fitment
Variable Valve Timing (VVT)

VVT Oil Control Solenoid Valve

4.6 / 5.0 (Direct Fit)

Restores accurate camshaft timing and oil pressure regulation on Dodge Durango.

$34 – $65 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Dodge DurangoVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Dodge Durango

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Dodge Durango:

4. Dodge Durango P0117 FAQs

What causes code P0117 to trigger on a Dodge Durango?

On the Dodge Durango (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 (360HP) / 6.4L 392 SRT (475HP)), P0117 is most frequently caused by ECT sensor internal short to ground or Short circuit to ground in ECT signal wiring harness.

Where is the OBD-II port located on my Dodge Durango?

On the Dodge Durango, the 16-pin DLC diagnostic connector is located Driver lower dash panel near fuse box. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Dodge Durango with code P0117?

No. The ECU thinks the engine is at 280°F+ (overheating) and runs rich or disables cooling fan logic. Given that P0117 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.