FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
P0455TeslaTesla Platform HubMaster P0455 GuideLow Severity

P0455 on Tesla: Symptoms, Causes & DIY Fix

Official technical diagnostic wire for fault code P0455 (P0455: Evaporative Emission Control System Leak Detected (Gross Leak)) specifically affecting Tesla vehicles (Model 3, Model Y, Model S, Model X, Cybertruck).

DIY Parts Estimate
$15 - $250 (DIY: $15 - $50)
Tesla OEM Direct Fit
Shop Labor Quote
$180 – $380
Based on $195/hr labor
Drivability Status
Drivable (Short Trip)
Low urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0455 On Another Make:
ToyotaBMWMercedes-BenzLexusFordHyundaiCadillacTeslaChevroletHondaAudiNissanJeepKiaSubaruRAMGMCVolkswagenMazdaDodgeVolvoBuickLincolnChryslerAcura

1. Symptoms of P0455 on Tesla

When the Engine Control Module (ECM/PCM) on your Tesla logs fault code P0455, drivers commonly observe:

Check Engine Light on on Tesla (Model 3, Model Y)
Gas cap loose warning message on dashboard on Tesla (Model 3, Model Y)
Slight fuel vapor odor near rear of vehicle on Tesla (Model 3, Model Y)

2. Most Likely Causes on Tesla

Historical warranty claims and technical repair bulletins for Tesla point to the following failure distribution:

55%
Missing, loose, or cracked gas cap seal (Tesla OEM Part)
25%
Faulty EVAP purge control solenoid (Tesla OEM Part)
12%
Stuck open EVAP vent valve (Tesla OEM Part)
8%
Cracked EVAP charcoal canister vapor hose (Tesla OEM Part)

3. Step-by-Step DIY Repair Guide for Tesla

01
Inspect and Tighten the Gas Cap

Remove gas cap, inspect rubber O-ring for cracks, tighten until it clicks 3 times. on Tesla vehicles (Model 3, Model Y).

Required Tool: None
02
Replace Gas Cap with OEM Replacement

If the cap rubber is dried or cracked, replace with genuine OEM cap ($15). on Tesla vehicles (Model 3, Model Y).

Required Tool: New OEM Gas Cap
03
Test EVAP Purge Solenoid Under Hood

Disconnect electrical plug and vacuum hose. Apply 12V; verify valve seals tight when unpowered. on Tesla vehicles (Model 3, Model Y).

Required Tool: 12V Probe, Vacuum Pump
04
Inspect EVAP Canister Vent Valve Near Gas Tank

Check vent valve for road salt corrosion or spider nest clogs. on Tesla vehicles (Model 3, Model Y).

Required Tool: Flashlight, Jack Stands
05
Smoke Test EVAP System

Pump mineral oil smoke into EVAP port to reveal any hairline cracked lines. on Tesla vehicles (Model 3, Model Y).

Required Tool: EVAP Smoke Machine

P0455 Guides by Tesla Model

Select your specific Tesla model below for exact OBD-II DLC port locations, wiring diagrams, and engine displacement specs:

Other Common Diagnostic Codes on Tesla

Troubleshoot other high-frequency Check Engine Light fault codes reported across Tesla vehicles:

4. Tesla P0455 FAQs

What causes code P0455 to trigger on a Tesla?

On Tesla vehicles, P0455 is most frequently caused by Missing, loose, or cracked gas cap seal or Faulty EVAP purge control solenoid. Factory sensor degradation or wiring harness wear near the engine bay are common factors.

Can I safely drive my Tesla with code P0455?

Yes. Completely safe to drive, but emissions test will fail. Given that P0455 carries a Low severity rating on Tesla vehicles, we advise performing diagnostic scanning via the OBD-II port before extended driving.

How much does it cost to fix P0455 on a Tesla?

DIY replacement parts typically range between $15 - $250 (DIY: $15 - $50). If serviced at an authorized Tesla dealership, expect an additional $120–$250 in professional labor based on their $195/hr hourly rate.