FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0455 on Tesla Model Y: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0455 (P0455: Evaporative Emission Control System Leak Detected (Gross Leak)) specifically on the Tesla Model Y (2020–2026, Dual Motor AWD Long Range / Performance (0-60 in 3.5s)).

Tesla Model Y
DIY Parts Estimate
$15 - $250 (DIY: $15 - $50)
Model Y OEM Fitment
Shop Labor Quote
$180 – $380
Based on $195/hr labor
Drivability Status
Drivable (Short Trip)
Low urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0455 On Another Tesla Model:
Tesla Model 3Tesla Model YTesla Model STesla Model XTesla Cybertruck

1. Symptoms of P0455 on Tesla Model Y

When the Engine Control Module (ECM/PCM) on your Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s)) logs fault code P0455, drivers commonly observe:

Check Engine Light on on Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s))
Gas cap loose warning message on dashboard on Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s))
Slight fuel vapor odor near rear of vehicle on Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s))
Tesla Model Y OBD-II Port Location
The 16-pin diagnostic connector is located Beneath steering wheel lower cover assembly. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Tesla Model Y

Historical warranty claims and technical repair bulletins for Tesla Model Y point to the following failure distribution:

55%
Missing, loose, or cracked gas cap seal (Tesla OEM Part)
25%
Faulty EVAP purge control solenoid (Tesla OEM Part)
12%
Stuck open EVAP vent valve (Tesla OEM Part)
8%
Cracked EVAP charcoal canister vapor hose (Tesla OEM Part)

3. Step-by-Step DIY Repair Guide for Tesla Model Y

01
Inspect and Tighten the Gas Cap

Remove gas cap, inspect rubber O-ring for cracks, tighten until it clicks 3 times. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).

Required Tool: None
02
Replace Gas Cap with OEM Replacement

If the cap rubber is dried or cracked, replace with genuine OEM cap ($15). on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).

Required Tool: New OEM Gas Cap
03
Test EVAP Purge Solenoid Under Hood

Disconnect electrical plug and vacuum hose. Apply 12V; verify valve seals tight when unpowered. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).

Required Tool: 12V Probe, Vacuum Pump
04
Inspect EVAP Canister Vent Valve Near Gas Tank

Check vent valve for road salt corrosion or spider nest clogs. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).

Required Tool: Flashlight, Jack Stands
05
Smoke Test EVAP System

Pump mineral oil smoke into EVAP port to reveal any hairline cracked lines. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).

Required Tool: EVAP Smoke Machine

Other Common Fault Codes on Tesla Model Y

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Tesla Model Y:

4. Tesla Model Y P0455 FAQs

What causes code P0455 to trigger on a Tesla Model Y?

On the Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s)), P0455 is most frequently caused by Missing, loose, or cracked gas cap seal or Faulty EVAP purge control solenoid.

Where is the OBD-II port located on my Tesla Model Y?

On the Tesla Model Y, the 16-pin DLC diagnostic connector is located Beneath steering wheel lower cover assembly. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Tesla Model Y with code P0455?

Yes. Completely safe to drive, but emissions test will fail. Given that P0455 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.