B1325 on Toyota Highlander: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code B1325 (B1325: Device Power 1 Circuit Voltage Below Threshold (BCM)) specifically on the Toyota Highlander (2020–2026, 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid).
1. Symptoms of B1325 on Toyota Highlander
When the Engine Control Module (ECM/PCM) on your Toyota Highlander (2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid) logs fault code B1325, drivers commonly observe:
2. Most Likely Causes on Toyota Highlander
Historical warranty claims and technical repair bulletins for Toyota Highlander point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Toyota Highlander
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether B1325 is static or intermittent. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.
Visually inspect the physical component (Main BCM Ground Wire), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.
Other Common Fault Codes on Toyota Highlander
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Toyota Highlander:
4. Toyota Highlander B1325 FAQs
What causes code B1325 to trigger on a Toyota Highlander?
On the Toyota Highlander (2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid), B1325 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Main BCM Ground Wire) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Toyota Highlander?
On the Toyota Highlander, the 16-pin DLC diagnostic connector is located Under driver steering column near kick panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Toyota Highlander with code B1325?
Caution. Limited operation permitted only to reach a nearby repair facility or backup critical personal files. Given that B1325 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.