P0760 on Tesla Model Y: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0760 (P0760: Shift Solenoid C Malfunction) specifically on the Tesla Model Y (2020–2026, Dual Motor AWD Long Range / Performance (0-60 in 3.5s)).
1. Symptoms of P0760 on Tesla Model Y
When the Engine Control Module (ECM/PCM) on your Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s)) logs fault code P0760, drivers commonly observe:
2. Most Likely Causes on Tesla Model Y
Historical warranty claims and technical repair bulletins for Tesla Model Y point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Tesla Model Y
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0760 is static or intermittent. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).
Visually inspect the physical component (Shift Solenoid C), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Tesla Model Y equipped with Dual Motor AWD Long Range / Performance (0-60 in 3.5s).
Other Common Fault Codes on Tesla Model Y
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Tesla Model Y:
4. Tesla Model Y P0760 FAQs
What causes code P0760 to trigger on a Tesla Model Y?
On the Tesla Model Y (Dual Motor AWD Long Range / Performance (0-60 in 3.5s)), P0760 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Shift Solenoid C) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Tesla Model Y?
On the Tesla Model Y, the 16-pin DLC diagnostic connector is located Beneath steering wheel lower cover assembly. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Tesla Model Y with code P0760?
Caution. Limited operation permitted only to reach a nearby repair facility or backup critical personal files. Given that P0760 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.