P0352 on Subaru WRX
Factory diagnostic protocol and troubleshooting wire for fault code P0352 specifically for the Subaru WRX (2022–2026, 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI)).
1. Symptoms of P0352 on Subaru WRX
When the Engine Control Module (ECM/PCM) on your Subaru WRX (2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI)) logs fault code P0352, drivers commonly observe:
2. Most Likely Causes on Subaru WRX
Historical warranty claims and technical repair bulletins for Subaru WRX point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Subaru WRX
Swap Coil 2 with Coil 1. If code becomes P0351, replace coil. on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).
Verify 12V power and trigger pulse. on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).
Replace Coil B with OEM part. on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).
Clear DTCs and confirm zero misfires. on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).
Equipment for Diagnosing Subaru WRX (P0352)
Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)
Pre-gapped iridium spark plugs engineered to restore smooth combustion on Subaru WRX.
Magnetic Swivel Spark Plug Socket Set
360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Subaru WRX
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Subaru WRX:
4. Subaru WRX P0352 FAQs
What causes code P0352 to trigger on a Subaru WRX?
On the Subaru WRX (2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI)), P0352 is most frequently caused by Dead Cylinder 2 ignition coil or Damaged harness wiring.
Where is the OBD-II port located on my Subaru WRX?
On the Subaru WRX, the 16-pin DLC diagnostic connector is located Driver lower dash near fuse panel access door. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Subaru WRX with code P0352?
No. Cylinder 2 ignition coil has failed. Given that P0352 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.