MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0455 on Subaru WRX

Evaporative Emission Control System Leak Detected (Gross Leak)

Factory diagnostic protocol and troubleshooting wire for fault code P0455 specifically for the Subaru WRX (2022–2026, 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI)).

Verified OEM Telemetry & Field Repair Tree
Subaru WRX2022–2026
Subaru WRX
Sedan2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
WRX SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
Low urgency level
Est. Repair Cost
$15 - $250 (DIY: $15 - $50)
Parts & Labor DIY
Check P0455 On Another Subaru Model:
Diagnose P0455 on Specific WRX Model Year:

1. Symptoms of P0455 on Subaru WRX

When the Engine Control Module (ECM/PCM) on your Subaru WRX (2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI)) logs fault code P0455, drivers commonly observe:

Check Engine Light on on Subaru WRX (2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI))
Gas cap loose warning message on dashboard on Subaru WRX (2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI))
Slight fuel vapor odor near rear of vehicle on Subaru WRX (2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI))
Subaru WRX OBD-II Port Location
The 16-pin diagnostic connector is located Driver lower dash near fuse panel access door. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Subaru WRX

Historical warranty claims and technical repair bulletins for Subaru WRX point to the following failure distribution:

55%
Missing, loose, or cracked gas cap seal (Subaru OEM Part)
25%
Faulty EVAP purge control solenoid (Subaru OEM Part)
12%
Stuck open EVAP vent valve (Subaru OEM Part)
8%
Cracked EVAP charcoal canister vapor hose (Subaru OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Subaru WRX.

3. Step-by-Step DIY Repair Guide for Subaru WRX

01
Inspect and Tighten the Gas Cap

Remove gas cap, inspect rubber O-ring for cracks, tighten until it clicks 3 times. on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).

Required Tool: None
02
Replace Gas Cap with OEM Replacement

If the cap rubber is dried or cracked, replace with genuine OEM cap ($15). on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).

Required Tool: New OEM Gas Cap
03
Test EVAP Purge Solenoid Under Hood

Disconnect electrical plug and vacuum hose. Apply 12V; verify valve seals tight when unpowered. on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).

Required Tool: 12V Probe, Vacuum Pump
04
Inspect EVAP Canister Vent Valve Near Gas Tank

Check vent valve for road salt corrosion or spider nest clogs. on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).

Required Tool: Flashlight, Jack Stands
05
Smoke Test EVAP System

Pump mineral oil smoke into EVAP port to reveal any hairline cracked lines. on the Subaru WRX equipped with 2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI).

Required Tool: EVAP Smoke Machine
Recommended Parts & Testing Tools

Equipment for Diagnosing Subaru WRX (P0455)

Prime Fast Delivery & Verified Fitment
EVAP Seal Replacement

OEM Tethered Fuel Gas Cap with O-Ring

4.7 / 5.0 (Direct Fit)

Tight-sealing factory fuel cap resolves common EVAP small/large leak codes without workshop visits.

$17 – $26 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Subaru WRXVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Subaru WRX

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Subaru WRX:

4. Subaru WRX P0455 FAQs

What causes code P0455 to trigger on a Subaru WRX?

On the Subaru WRX (2.4L Turbocharged FA24F Boxer-4 (271HP WRX / 350HP STI)), P0455 is most frequently caused by Missing, loose, or cracked gas cap seal or Faulty EVAP purge control solenoid.

Where is the OBD-II port located on my Subaru WRX?

On the Subaru WRX, the 16-pin DLC diagnostic connector is located Driver lower dash near fuse panel access door. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Subaru WRX with code P0455?

Yes. Completely safe to drive, but emissions test will fail. Given that P0455 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.