U0104 on Subaru Crosstrek
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Subaru Crosstrek (2021–2026, 2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP)).
1. Symptoms of U0104 on Subaru Crosstrek
When the Engine Control Module (ECM/PCM) on your Subaru Crosstrek (2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP)) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Subaru Crosstrek
Historical warranty claims and technical repair bulletins for Subaru Crosstrek point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Subaru Crosstrek
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Subaru Crosstrek equipped with 2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP).
Verify power feed to radar sensor. on the Subaru Crosstrek equipped with 2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP).
Execute optical/radar alignment procedure if bumper was removed. on the Subaru Crosstrek equipped with 2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP).
Clear DTCs and test cruise on highway. on the Subaru Crosstrek equipped with 2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP).
Equipment for Diagnosing Subaru Crosstrek (U0104)
Subaru Crosstrek OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Subaru Crosstrek.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Subaru Crosstrek
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Subaru Crosstrek:
4. Subaru Crosstrek U0104 FAQs
What causes code U0104 to trigger on a Subaru Crosstrek?
On the Subaru Crosstrek (2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP)), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Subaru Crosstrek?
On the Subaru Crosstrek, the 16-pin DLC diagnostic connector is located Under driver side steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Subaru Crosstrek with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.