P0117 on Subaru Crosstrek
Factory diagnostic protocol and troubleshooting wire for fault code P0117 specifically for the Subaru Crosstrek (2021–2026, 2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP)).
1. Symptoms of P0117 on Subaru Crosstrek
When the Engine Control Module (ECM/PCM) on your Subaru Crosstrek (2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP)) logs fault code P0117, drivers commonly observe:
2. Most Likely Causes on Subaru Crosstrek
Historical warranty claims and technical repair bulletins for Subaru Crosstrek point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Subaru Crosstrek
Read ECT live PID on scanner. If it reads 284°F (140°C) or higher with engine cold, a short to ground exists. on the Subaru Crosstrek equipped with 2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP).
Unplug sensor connector while watching live data. If temperature drops to -40°F (-40°C), the sensor itself is shorted. on the Subaru Crosstrek equipped with 2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP).
If reading stays pegged at max with sensor unplugged, inspect harness for pinch points grounding against engine block. on the Subaru Crosstrek equipped with 2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP).
Allow engine to cool, unscrew old ECT sensor from coolant crossover pipe or thermostat housing, install new OEM sensor with fresh thread sealant. on the Subaru Crosstrek equipped with 2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP).
Bleed air from cooling system, clear DTCs, and verify normal temperature rise on live data. on the Subaru Crosstrek equipped with 2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP).
Equipment for Diagnosing Subaru Crosstrek (P0117)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on Subaru Crosstrek.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Subaru Crosstrek
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Subaru Crosstrek:
4. Subaru Crosstrek P0117 FAQs
What causes code P0117 to trigger on a Subaru Crosstrek?
On the Subaru Crosstrek (2.0L Boxer-4 (152HP) / 2.5L (182HP) / 2.0L PHEV Plug-In Hybrid (149HP)), P0117 is most frequently caused by ECT sensor internal short to ground or Short circuit to ground in ECT signal wiring harness.
Where is the OBD-II port located on my Subaru Crosstrek?
On the Subaru Crosstrek, the 16-pin DLC diagnostic connector is located Under driver side steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Subaru Crosstrek with code P0117?
No. The ECU thinks the engine is at 280°F+ (overheating) and runs rich or disables cooling fan logic. Given that P0117 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.