B0091 on Nissan Rogue
Factory diagnostic protocol and troubleshooting wire for fault code B0091 specifically for the Nissan Rogue (2021–2026, 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft)).
1. Symptoms of B0091 on Nissan Rogue
When the Engine Control Module (ECM/PCM) on your Nissan Rogue (1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft)) logs fault code B0091, drivers commonly observe:
2. Most Likely Causes on Nissan Rogue
Historical warranty claims and technical repair bulletins for Nissan Rogue point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Nissan Rogue
Disconnect battery negative cable and wait 15 minutes to fully discharge SRS backup capacitors before touching airbag components. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).
Remove driver side door sill trim / lower B-pillar trim to access the yellow impact sensor. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).
Inspect sensor for water corrosion or cracked plastic housing. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).
Bolt new OEM side impact sensor into clean, rust-free ground location, torque bolt to spec, and click yellow locking connector firmly. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).
Reconnect battery, clear SRS trouble codes with an airbag-capable scanner, and verify light turns off after 5-second bulb check. on the Nissan Rogue equipped with 1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft).
Equipment for Diagnosing Nissan Rogue (B0091)
Nissan Rogue OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Nissan Rogue.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Nissan Rogue
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Nissan Rogue:
4. Nissan Rogue B0091 FAQs
What causes code B0091 to trigger on a Nissan Rogue?
On the Nissan Rogue (1.5L 3-Cyl VC-Turbo (201HP / 225 lb-ft)), B0091 is most frequently caused by Corroded or damaged left side impact crash sensor (B-pillar or door sill) or Corroded wiring harness under driver seat / driver door sill.
Where is the OBD-II port located on my Nissan Rogue?
On the Nissan Rogue, the 16-pin DLC diagnostic connector is located Driver lower dash trim near driver left foot. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Nissan Rogue with code B0091?
Caution. Side curtain and seat airbag deployment may be disabled in a side-impact collision. Given that B0091 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.