MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0443 on Nissan Pathfinder

EVAP System Purge Control Valve Circuit Malfunction

Factory diagnostic protocol and troubleshooting wire for fault code P0443 specifically for the Nissan Pathfinder (2022–2026, 3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto)).

Verified OEM Telemetry & Field Repair Tree
Nissan Pathfinder2022–2026
Nissan Pathfinder
SUV3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
Pathfinder SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. Repair Cost
$90 - $250 (DIY: $25 - $70)
Parts & Labor DIY
Check P0443 On Another Nissan Model:
Diagnose P0443 on Specific Pathfinder Model Year:

1. Symptoms of P0443 on Nissan Pathfinder

When the Engine Control Module (ECM/PCM) on your Nissan Pathfinder (3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto)) logs fault code P0443, drivers commonly observe:

Check Engine Light on on Nissan Pathfinder (3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto))
Engine hard to start immediately after pumping gas at the gas station on Nissan Pathfinder (3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto))
Rough or fluctuating engine idle on Nissan Pathfinder (3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto))
Slight fuel odor under hood on Nissan Pathfinder (3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto))
Nissan Pathfinder OBD-II Port Location
The 16-pin diagnostic connector is located Driver side lower dash trim near fuse panel. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Nissan Pathfinder

Historical warranty claims and technical repair bulletins for Nissan Pathfinder point to the following failure distribution:

55%
Failed EVAP purge solenoid coil (open or shorted internally) (Nissan OEM Part)
25%
Broken or frayed wiring harness to purge valve connector (Nissan OEM Part)
12%
Blown EVAP fuse in fuse block (Nissan OEM Part)
8%
Corroded pins inside electrical plug (Nissan OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Nissan Pathfinder.

3. Step-by-Step DIY Repair Guide for Nissan Pathfinder

01
Locate EVAP Purge Solenoid Under Hood

Find the purge valve mounted on the intake manifold with one vacuum line leading to the intake and one to the charcoal canister. on the Nissan Pathfinder equipped with 3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto).

Required Tool: Flashlight
02
Test Purge Valve Solenoid Resistance

Unplug 2-pin connector and measure resistance across terminals with multimeter. Typical spec is 14–30 ohms. If open (OL) or shorted (0 ohms), solenoid is dead. on the Nissan Pathfinder equipped with 3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto).

Required Tool: Digital Multimeter
03
Test Vacuum Sealing

Remove purge valve and blow into it. A healthy de-energized purge valve should be 100% sealed. If air passes through, the internal seal is stuck open. on the Nissan Pathfinder equipped with 3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto).

Required Tool: Hand Vacuum Pump
04
Replace EVAP Purge Valve

Disconnect quick-release vapor lines, unbolt mounting bracket, snap new OEM purge valve into place, and reconnect electrical plug. on the Nissan Pathfinder equipped with 3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto).

Required Tool: 10mm Socket, Pliers
05
Clear Codes

Clear DTCs with scanner and verify EVAP monitor completes. on the Nissan Pathfinder equipped with 3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto).

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Nissan Pathfinder (P0443)

Prime Fast Delivery & Verified Fitment
EVAP Seal Replacement

OEM Tethered Fuel Gas Cap with O-Ring

4.7 / 5.0 (Direct Fit)

Tight-sealing factory fuel cap resolves common EVAP small/large leak codes without workshop visits.

$17 – $26 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Nissan PathfinderVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Nissan Pathfinder

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Nissan Pathfinder:

4. Nissan Pathfinder P0443 FAQs

What causes code P0443 to trigger on a Nissan Pathfinder?

On the Nissan Pathfinder (3.5L DOHC V6 (284HP / 7-Passenger / 9-Speed Auto)), P0443 is most frequently caused by Failed EVAP purge solenoid coil (open or shorted internally) or Broken or frayed wiring harness to purge valve connector.

Where is the OBD-II port located on my Nissan Pathfinder?

On the Nissan Pathfinder, the 16-pin DLC diagnostic connector is located Driver side lower dash trim near fuse panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Nissan Pathfinder with code P0443?

Yes. Safe to drive, but engine may experience hard starting after refueling at gas station. Given that P0443 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.