MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0443 on Nissan: Symptoms, Causes & Fix

EVAP System Purge Control Valve Circuit Malfunction

Official technical diagnostic wire for fault code P0443 specifically affecting Nissan vehicles (Altima, Rogue, Sentra, Pathfinder, Frontier).

Sensor Voltage Ref
0.1V – 5.0V Ref
Nissan Factory Standard
CAN Bus Speed
500 kbps CAN-FD
ISO 15765-4 Diagnostic Bus
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. Repair Cost
$90 - $250 (DIY: $25 - $70)
Parts & Labor DIY
Model-Specific Diagnostic Wires

Select Your Nissan Model for P0443:

6 Models Available

1. Common Symptoms on Nissan Vehicles

When Nissan Engine Control Modules (ECM) trigger fault code P0443, drivers typically report:

Check Engine Light on on Nissan Powertrains
Engine hard to start immediately after pumping gas at the gas station on Nissan Powertrains
Rough or fluctuating engine idle on Nissan Powertrains
Slight fuel odor under hood on Nissan Powertrains

2. Root Causes on Nissan Engines

Historical diagnostic claims across Nissan engines point to the following failure distribution:

55%
Failed EVAP purge solenoid coil (open or shorted internally) (Nissan OEM Part)
25%
Broken or frayed wiring harness to purge valve connector (Nissan OEM Part)
12%
Blown EVAP fuse in fuse block (Nissan OEM Part)
8%
Corroded pins inside electrical plug (Nissan OEM Part)

3. Step-by-Step Fix Protocol for Nissan

01
Locate EVAP Purge Solenoid Under Hood

Find the purge valve mounted on the intake manifold with one vacuum line leading to the intake and one to the charcoal canister. on Nissan engines.

Required Tool: Flashlight
02
Test Purge Valve Solenoid Resistance

Unplug 2-pin connector and measure resistance across terminals with multimeter. Typical spec is 14–30 ohms. If open (OL) or shorted (0 ohms), solenoid is dead. on Nissan engines.

Required Tool: Digital Multimeter
03
Test Vacuum Sealing

Remove purge valve and blow into it. A healthy de-energized purge valve should be 100% sealed. If air passes through, the internal seal is stuck open. on Nissan engines.

Required Tool: Hand Vacuum Pump
04
Replace EVAP Purge Valve

Disconnect quick-release vapor lines, unbolt mounting bracket, snap new OEM purge valve into place, and reconnect electrical plug. on Nissan engines.

Required Tool: 10mm Socket, Pliers
05
Clear Codes

Clear DTCs with scanner and verify EVAP monitor completes. on Nissan engines.

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Nissan (P0443)

Prime Fast Delivery & Verified Fitment
EVAP Seal Replacement

OEM Tethered Fuel Gas Cap with O-Ring

4.7 / 5.0 (Direct Fit)

Tight-sealing factory fuel cap resolves common EVAP small/large leak codes without workshop visits.

$17 – $26 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for NissanVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

4. Nissan P0443 Frequently Asked Questions

What does code P0443 mean on a Nissan?

On Nissan vehicles, P0443 indicates that the Engine Control Module (ECM) detected evap system purge control valve circuit malfunction. This typically points to Failed EVAP purge solenoid coil (open or shorted internally) or Broken or frayed wiring harness to purge valve connector.

Can I continue driving my Nissan with code P0443?

Yes. Safe to drive, but engine may experience hard starting after refueling at gas station. Because this code carries a Medium severity rating on Nissan powertrains, we recommend scanning live data values promptly to prevent secondary damage.

How much does it cost to fix code P0443 on a Nissan?

Estimated DIY parts cost ranges from $90 - $250 (DIY: $25 - $70), while professional shop repairs at an authorized Nissan dealership or independent specialist typically range from $180 to $380 including diagnostic labor.