FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0507 on Mercedes-Benz GLC: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0507 (Idle Control System RPM Higher Than Expected - Diagnosis) specifically on the Mercedes-Benz GLC (2020–2026, 2.0L Turbo 4-Cyl with EQ Boost (255HP) / AMG GLC 43 4MATIC).

Mercedes-Benz GLC
DIY Parts Estimate
$40 - $250 (DIY Throttle Relearn: $0)
GLC OEM Fitment
Shop Labor Quote
$180 – $380
Based on $185/hr labor
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0507 On Another Mercedes-Benz Model:
Mercedes-Benz C-ClassMercedes-Benz E-ClassMercedes-Benz S-ClassMercedes-Benz GLCMercedes-Benz GLEMercedes-Benz GLSMercedes-Benz G-Class

1. Symptoms of P0507 on Mercedes-Benz GLC

When the Engine Control Module (ECM/PCM) on your Mercedes-Benz GLC (2.0L Turbo 4-Cyl with EQ Boost (255HP) / AMG GLC 43 4MATIC) logs fault code P0507, drivers commonly observe:

Engine idles at 1,000+ RPM in park/neutral on Mercedes-Benz GLC (2.0L Turbo 4-Cyl with EQ Boost (255HP) / AMG GLC 43 4MATIC)
RPM surges or hunts at red lights on Mercedes-Benz GLC (2.0L Turbo 4-Cyl with EQ Boost (255HP) / AMG GLC 43 4MATIC)
Check Engine Light illuminated on Mercedes-Benz GLC (2.0L Turbo 4-Cyl with EQ Boost (255HP) / AMG GLC 43 4MATIC)
Mercedes-Benz GLC OBD-II Port Location
The 16-pin diagnostic connector is located Driver lower kick panel near hood release lever. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Mercedes-Benz GLC

Historical warranty claims and technical repair bulletins for Mercedes-Benz GLC point to the following failure distribution:

55%
Intake manifold vacuum leak (Mercedes-Benz OEM Part)
25%
Carbon buildup causing sticky electronic throttle body (Mercedes-Benz OEM Part)
12%
Uncalibrated idle air volume after battery disconnect (Mercedes-Benz OEM Part)
8%
Faulty PCV valve stuck open (Mercedes-Benz OEM Part)

3. Step-by-Step DIY Repair Guide for Mercedes-Benz GLC

01
Check for Unmetered Vacuum Leaks

Spray brake cleaner around intake manifold gaskets; an RPM change reveals the leak location. on the Mercedes-Benz GLC equipped with 2.0L Turbo 4-Cyl with EQ Boost (255HP) / AMG GLC 43 4MATIC.

02
Clean Throttle Body & Carbon Deposits

Gently clean carbon soot around throttle blade using throttle cleaner and microfiber towel. on the Mercedes-Benz GLC equipped with 2.0L Turbo 4-Cyl with EQ Boost (255HP) / AMG GLC 43 4MATIC.

03
Perform Idle Air Volume Relearn Procedure

Follow vehicle-specific ignition key on/off timing sequence or use OBD scanner to reset baseline idle. on the Mercedes-Benz GLC equipped with 2.0L Turbo 4-Cyl with EQ Boost (255HP) / AMG GLC 43 4MATIC.

Other Common Fault Codes on Mercedes-Benz GLC

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Mercedes-Benz GLC:

4. Mercedes-Benz GLC P0507 FAQs

What causes code P0507 to trigger on a Mercedes-Benz GLC?

On the Mercedes-Benz GLC (2.0L Turbo 4-Cyl with EQ Boost (255HP) / AMG GLC 43 4MATIC), P0507 is most frequently caused by Intake manifold vacuum leak or Carbon buildup causing sticky electronic throttle body.

Where is the OBD-II port located on my Mercedes-Benz GLC?

On the Mercedes-Benz GLC, the 16-pin DLC diagnostic connector is located Driver lower kick panel near hood release lever. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Mercedes-Benz GLC with code P0507?

Driveable, but braking distance may increase slightly due to high engine idle. Given that P0507 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.