P0335 on Jeep Grand Cherokee: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0335 (P0335: Crankshaft Position Sensor A Circuit Malfunction) specifically on the Jeep Grand Cherokee (2021–2026, 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP)).
1. Symptoms of P0335 on Jeep Grand Cherokee
When the Engine Control Module (ECM/PCM) on your Jeep Grand Cherokee (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP)) logs fault code P0335, drivers commonly observe:
2. Most Likely Causes on Jeep Grand Cherokee
Historical warranty claims and technical repair bulletins for Jeep Grand Cherokee point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Jeep Grand Cherokee
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0335 is static or intermittent. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Visually inspect the physical component (Crankshaft Position (CKP) Sensor), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Jeep Grand Cherokee equipped with 3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP).
Other Common Fault Codes on Jeep Grand Cherokee
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Jeep Grand Cherokee:
4. Jeep Grand Cherokee P0335 FAQs
What causes code P0335 to trigger on a Jeep Grand Cherokee?
On the Jeep Grand Cherokee (3.6L Pentastar V6 (293HP) / 5.7L HEMI V8 / 4xe PHEV (375HP)), P0335 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Crankshaft Position (CKP) Sensor) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Jeep Grand Cherokee?
On the Jeep Grand Cherokee, the 16-pin DLC diagnostic connector is located Under driver side dashboard above foot pedals. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Jeep Grand Cherokee with code P0335?
No. Immediate shutdown / repair required to prevent permanent hardware destruction or total system lockup. Given that P0335 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.