P0137 on Jeep Cherokee
Factory diagnostic protocol and troubleshooting wire for fault code P0137 specifically for the Jeep Cherokee (2020–2026, 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6).
1. Symptoms of P0137 on Jeep Cherokee
When the Engine Control Module (ECM/PCM) on your Jeep Cherokee (2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6) logs fault code P0137, drivers commonly observe:
2. Most Likely Causes on Jeep Cherokee
Historical warranty claims and technical repair bulletins for Jeep Cherokee point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Jeep Cherokee
Listen for exhaust ticking or black soot around flex pipe, flanges, and sensor bungs before the catalytic converter. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Monitor B1S2 voltage. Snap the throttle to enrich mixture; voltage should briefly spike above 0.8V. If it remains 0.0V–0.1V, sensor is defective or shorted. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Unplug harness, remove old sensor with 7/8 socket, install replacement sensor and plug firmly. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Clear DTCs and verify B1S2 holds steady between 0.45V and 0.75V during steady highway cruising. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Equipment for Diagnosing Jeep Cherokee (P0137)
Jeep Cherokee OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Jeep Cherokee.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Jeep Cherokee
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Jeep Cherokee:
4. Jeep Cherokee P0137 FAQs
What causes code P0137 to trigger on a Jeep Cherokee?
On the Jeep Cherokee (2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6), P0137 is most frequently caused by Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air or Faulty downstream oxygen sensor.
Where is the OBD-II port located on my Jeep Cherokee?
On the Jeep Cherokee, the 16-pin DLC diagnostic connector is located Under driver side lower dash trim panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Jeep Cherokee with code P0137?
Yes. Vehicle is fully drivable, but Check Engine Light will remain illuminated. Given that P0137 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.