B0091 on Dodge Hornet
Factory diagnostic protocol and troubleshooting wire for fault code B0091 specifically for the Dodge Hornet (2023–2026, 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)).
1. Symptoms of B0091 on Dodge Hornet
When the Engine Control Module (ECM/PCM) on your Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)) logs fault code B0091, drivers commonly observe:
2. Most Likely Causes on Dodge Hornet
Historical warranty claims and technical repair bulletins for Dodge Hornet point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Dodge Hornet
Disconnect battery negative cable and wait 15 minutes to fully discharge SRS backup capacitors before touching airbag components. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Remove driver side door sill trim / lower B-pillar trim to access the yellow impact sensor. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Inspect sensor for water corrosion or cracked plastic housing. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Bolt new OEM side impact sensor into clean, rust-free ground location, torque bolt to spec, and click yellow locking connector firmly. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Reconnect battery, clear SRS trouble codes with an airbag-capable scanner, and verify light turns off after 5-second bulb check. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Equipment for Diagnosing Dodge Hornet (B0091)
Dodge Hornet OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Dodge Hornet.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Dodge Hornet
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Dodge Hornet:
4. Dodge Hornet B0091 FAQs
What causes code B0091 to trigger on a Dodge Hornet?
On the Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)), B0091 is most frequently caused by Corroded or damaged left side impact crash sensor (B-pillar or door sill) or Corroded wiring harness under driver seat / driver door sill.
Where is the OBD-II port located on my Dodge Hornet?
On the Dodge Hornet, the 16-pin DLC diagnostic connector is located Under driver steering column lower trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Dodge Hornet with code B0091?
Caution. Side curtain and seat airbag deployment may be disabled in a side-impact collision. Given that B0091 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.