P0455 on 2014 Chrysler 300
Technical troubleshooting wire for fault code P0455 specifically tailored for the 2014 Chrysler 300. Includes wiring sensor pinouts, freeze frame PID parameters, and step-by-step diagnostic tree.
Common 2014 300 Symptoms
- Check Engine Light on
- Gas cap loose warning message on dashboard
- Slight fuel vapor odor near rear of vehicle
Likely Root Causes on 2014 300
- Missing, loose, or cracked gas cap seal
- Faulty EVAP purge control solenoid
- Stuck open EVAP vent valve
- Cracked EVAP charcoal canister vapor hose
Step-by-Step Fix Protocol for 2014 Chrysler 300
Connect an OBD-II scanner to the DLC port under the driver dashboard. Record engine RPM, Short Term / Long Term Fuel Trim (STFT/LTFT), and engine coolant temperature at the moment P0455 set.
Inspect the sensor connector on the 2014 300 engine bay. Use a multimeter to verify reference voltage (5.0V / 12.0V) and ground continuity.
Replace the verified defective component using OEM or equivalent grade parts. Clear DTC P0455 and complete an EPA drive cycle to verify readiness monitors set to READY.
Equipment for Diagnosing 2014 Chrysler 300 (P0455)
OEM Tethered Fuel Gas Cap with O-Ring
Tight-sealing factory fuel cap resolves common EVAP small/large leak codes without workshop visits.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.