P0302 on Cadillac Lyriq: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0302 (P0302: Cylinder 2 Misfire Detected) specifically on the Cadillac Lyriq (2023–2026, Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)).
1. Symptoms of P0302 on Cadillac Lyriq
When the Engine Control Module (ECM/PCM) on your Cadillac Lyriq (Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)) logs fault code P0302, drivers commonly observe:
2. Most Likely Causes on Cadillac Lyriq
Historical warranty claims and technical repair bulletins for Cadillac Lyriq point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Cadillac Lyriq
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0302 is static or intermittent. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Visually inspect the physical component (Cylinder 2 Ignition Coil / Plug), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Other Common Fault Codes on Cadillac Lyriq
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Cadillac Lyriq:
4. Cadillac Lyriq P0302 FAQs
What causes code P0302 to trigger on a Cadillac Lyriq?
On the Cadillac Lyriq (Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)), P0302 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Cylinder 2 Ignition Coil / Plug) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Cadillac Lyriq?
On the Cadillac Lyriq, the 16-pin DLC diagnostic connector is located Under driver steering column beneath knee bolster. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Cadillac Lyriq with code P0302?
No. Immediate shutdown / repair required to prevent permanent hardware destruction or total system lockup. Given that P0302 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.