P0300 on Cadillac Lyriq: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0300 (P0300: Random or Multiple Cylinder Misfire Detected) specifically on the Cadillac Lyriq (2023–2026, Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)).
1. Symptoms of P0300 on Cadillac Lyriq
When the Engine Control Module (ECM/PCM) on your Cadillac Lyriq (Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)) logs fault code P0300, drivers commonly observe:
2. Most Likely Causes on Cadillac Lyriq
Historical warranty claims and technical repair bulletins for Cadillac Lyriq point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Cadillac Lyriq
Plug a handheld OBD-II scanner into the 16-pin port under the dashboard. Check if specific cylinder codes like P0301 (Cylinder 1) or P0304 (Cylinder 4) accompany P0300. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Remove the ignition coils, use a spark plug socket with ratchet to unthread spark plugs. Inspect electrode tips for carbon buildup, oil fouling, or burnt gaps. Replace with OEM iridium plugs gapped to spec. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Perform an ignition swap test: Swap coil from a suspected misfiring cylinder to an adjacent cylinder. Clear codes and re-scan. If the misfire moves, replace the faulty coil. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Inspect PCV hoses, intake boot, and vacuum lines for cracking or hissing sounds while engine idles. Smoke test the intake if necessary. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Add a bottle of premium fuel injector cleaner (e.g. Chevron Techron). Clear the OBD-II codes with your scanner and take the car on a 15-minute drive cycle to confirm readiness monitors reset. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Other Common Fault Codes on Cadillac Lyriq
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Cadillac Lyriq:
4. Cadillac Lyriq P0300 FAQs
What causes code P0300 to trigger on a Cadillac Lyriq?
On the Cadillac Lyriq (Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)), P0300 is most frequently caused by Worn or fouled spark plugs and damaged spark plug wires or Failing ignition coils or coil packs.
Where is the OBD-II port located on my Cadillac Lyriq?
On the Cadillac Lyriq, the 16-pin DLC diagnostic connector is located Under driver steering column beneath knee bolster. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Cadillac Lyriq with code P0300?
No. Driving with a flashing check engine light causes irreversible catalytic converter damage. Given that P0300 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.