P0141 on Cadillac Lyriq: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0141 (P0141: O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 2)) specifically on the Cadillac Lyriq (2023–2026, Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)).
1. Symptoms of P0141 on Cadillac Lyriq
When the Engine Control Module (ECM/PCM) on your Cadillac Lyriq (Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)) logs fault code P0141, drivers commonly observe:
2. Most Likely Causes on Cadillac Lyriq
Historical warranty claims and technical repair bulletins for Cadillac Lyriq point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Cadillac Lyriq
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0141 is static or intermittent. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Visually inspect the physical component (Downstream Heated O2 Sensor), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Cadillac Lyriq equipped with Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP).
Other Common Fault Codes on Cadillac Lyriq
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Cadillac Lyriq:
4. Cadillac Lyriq P0141 FAQs
What causes code P0141 to trigger on a Cadillac Lyriq?
On the Cadillac Lyriq (Ultium Dual Motor AWD (500HP / 450 lb-ft) / Single Motor RWD (340HP)), P0141 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Downstream Heated O2 Sensor) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Cadillac Lyriq?
On the Cadillac Lyriq, the 16-pin DLC diagnostic connector is located Under driver steering column beneath knee bolster. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Cadillac Lyriq with code P0141?
Yes, for temporary operations. However, resolve promptly to maintain optimal efficiency and prevent cascade failures. Given that P0141 carries a Moderate severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.