U0104 on Audi e-tron
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Audi e-tron (2020–2026, Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP)).
1. Symptoms of U0104 on Audi e-tron
When the Engine Control Module (ECM/PCM) on your Audi e-tron (Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP)) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Audi e-tron
Historical warranty claims and technical repair bulletins for Audi e-tron point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Audi e-tron
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Verify power feed to radar sensor. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Execute optical/radar alignment procedure if bumper was removed. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Clear DTCs and test cruise on highway. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Equipment for Diagnosing Audi e-tron (U0104)
Audi e-tron OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Audi e-tron.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Audi e-tron
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Audi e-tron:
4. Audi e-tron U0104 FAQs
What causes code U0104 to trigger on a Audi e-tron?
On the Audi e-tron (Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP)), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Audi e-tron?
On the Audi e-tron, the 16-pin DLC diagnostic connector is located Driver footwell near OBD bulkhead interface. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Audi e-tron with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.