P0455 on Audi e-tron
Factory diagnostic protocol and troubleshooting wire for fault code P0455 specifically for the Audi e-tron (2020–2026, Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP)).
1. Symptoms of P0455 on Audi e-tron
When the Engine Control Module (ECM/PCM) on your Audi e-tron (Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP)) logs fault code P0455, drivers commonly observe:
2. Most Likely Causes on Audi e-tron
Historical warranty claims and technical repair bulletins for Audi e-tron point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Audi e-tron
Remove gas cap, inspect rubber O-ring for cracks, tighten until it clicks 3 times. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
If the cap rubber is dried or cracked, replace with genuine OEM cap ($15). on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Disconnect electrical plug and vacuum hose. Apply 12V; verify valve seals tight when unpowered. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Check vent valve for road salt corrosion or spider nest clogs. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Pump mineral oil smoke into EVAP port to reveal any hairline cracked lines. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Equipment for Diagnosing Audi e-tron (P0455)
OEM Tethered Fuel Gas Cap with O-Ring
Tight-sealing factory fuel cap resolves common EVAP small/large leak codes without workshop visits.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Audi e-tron
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Audi e-tron:
4. Audi e-tron P0455 FAQs
What causes code P0455 to trigger on a Audi e-tron?
On the Audi e-tron (Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP)), P0455 is most frequently caused by Missing, loose, or cracked gas cap seal or Faulty EVAP purge control solenoid.
Where is the OBD-II port located on my Audi e-tron?
On the Audi e-tron, the 16-pin DLC diagnostic connector is located Driver footwell near OBD bulkhead interface. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Audi e-tron with code P0455?
Yes. Completely safe to drive, but emissions test will fail. Given that P0455 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.

