P0352 on Audi e-tron
Factory diagnostic protocol and troubleshooting wire for fault code P0352 specifically for the Audi e-tron (2020–2026, Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP)).
1. Symptoms of P0352 on Audi e-tron
When the Engine Control Module (ECM/PCM) on your Audi e-tron (Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP)) logs fault code P0352, drivers commonly observe:
2. Most Likely Causes on Audi e-tron
Historical warranty claims and technical repair bulletins for Audi e-tron point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Audi e-tron
Swap Coil 2 with Coil 1. If code becomes P0351, replace coil. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Verify 12V power and trigger pulse. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Replace Coil B with OEM part. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Clear DTCs and confirm zero misfires. on the Audi e-tron equipped with Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP).
Equipment for Diagnosing Audi e-tron (P0352)
Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)
Pre-gapped iridium spark plugs engineered to restore smooth combustion on Audi e-tron.
Magnetic Swivel Spark Plug Socket Set
360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Audi e-tron
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Audi e-tron:
4. Audi e-tron P0352 FAQs
What causes code P0352 to trigger on a Audi e-tron?
On the Audi e-tron (Dual Motor AWD (400HP / e-tron GT quattro 469HP / RS 590HP)), P0352 is most frequently caused by Dead Cylinder 2 ignition coil or Damaged harness wiring.
Where is the OBD-II port located on my Audi e-tron?
On the Audi e-tron, the 16-pin DLC diagnostic connector is located Driver footwell near OBD bulkhead interface. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Audi e-tron with code P0352?
No. Cylinder 2 ignition coil has failed. Given that P0352 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.