P0404 on Acura TLX
Factory diagnostic protocol and troubleshooting wire for fault code P0404 specifically for the Acura TLX (2021–2026, 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD)).
1. Symptoms of P0404 on Acura TLX
When the Engine Control Module (ECM/PCM) on your Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD)) logs fault code P0404, drivers commonly observe:
2. Most Likely Causes on Acura TLX
Historical warranty claims and technical repair bulletins for Acura TLX point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Acura TLX
Compare commanded EGR percentage vs actual position voltage. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).
Clean carbon buildup restricting valve stroke. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).
If potentiometer is worn out, install new OEM electronic EGR valve. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).
Clear DTCs and complete an EGR monitor drive cycle. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).
Equipment for Diagnosing Acura TLX (P0404)
Acura TLX OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Acura TLX.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Acura TLX
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Acura TLX:
4. Acura TLX P0404 FAQs
What causes code P0404 to trigger on a Acura TLX?
On the Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD)), P0404 is most frequently caused by Carbon deposits restricting linear EGR pintle movement or Worn internal EGR position feedback potentiometer.
Where is the OBD-II port located on my Acura TLX?
On the Acura TLX, the 16-pin DLC diagnostic connector is located Driver footwell below steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Acura TLX with code P0404?
Yes. Normal drivability is maintained in most conditions. Given that P0404 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.