MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
P0087AcuraAcura TLX HubAll Acura P0087Critical Severity

P0087 on Acura TLX

Fuel Rail/System Pressure - Too Low

Factory diagnostic protocol and troubleshooting wire for fault code P0087 specifically for the Acura TLX (2021–2026, 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD)).

Verified OEM Telemetry & Field Repair Tree
Acura TLX2021–2026
Acura TLX
Sedan2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
TLX SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Not Recommended
Critical urgency level
Est. Repair Cost
$150 - $1,200 (DIY: $80 - $350)
Parts & Labor DIY
Check P0087 On Another Acura Model:
Diagnose P0087 on Specific TLX Model Year:

1. Symptoms of P0087 on Acura TLX

When the Engine Control Module (ECM/PCM) on your Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD)) logs fault code P0087, drivers commonly observe:

Check Engine Light illuminated on Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD))
Engine cranks but takes a long time to start (hard starting) on Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD))
Noticeable lack of engine power or acceleration hesitation on Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD))
Engine sputtering, surging, or dying under heavy throttle on Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD))
Accompanying misfire codes (P0300, P0301-P0306) on Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD))
Acura TLX OBD-II Port Location
The 16-pin diagnostic connector is located Driver footwell below steering column. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Acura TLX

Historical warranty claims and technical repair bulletins for Acura TLX point to the following failure distribution:

55%
Failing High-Pressure Fuel Pump (HPFP) (Acura OEM Part)
25%
Clogged fuel filter or restricted in-tank low-pressure fuel pump (LPFP) (Acura OEM Part)
12%
Faulty fuel rail pressure sensor (FRP) reading incorrectly (Acura OEM Part)
8%
Clogged or leaking fuel injector stuck open (Acura OEM Part)
8%
Faulty fuel pressure regulator or damaged fuel supply lines (Acura OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Acura TLX.

3. Step-by-Step DIY Repair Guide for Acura TLX

01
Scan Live Data for Desired vs Actual Fuel Rail Pressure

Connect an OBD-II scan tool and inspect live Mode $01 telemetry for Fuel Rail Pressure (FRP). Compare actual pressure against the ECU's desired setpoint during idle and 2,500 RPM revs. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).

Required Tool: OBD-II Scanner with Live Data
02
Test In-Tank Low Pressure Supply

Verify the low-pressure lift pump is delivering 55–75 PSI to the HPFP using a mechanical fuel pressure gauge on the Schrader valve. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).

Required Tool: Fuel Pressure Gauge Kit
03
Inspect Fuel Rail Pressure Sensor & Wiring

Check the 3-wire FRP sensor harness for 5V reference, ground, and signal voltage (typically 0.5V at key-on to 4.5V at peak pressure). on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).

Required Tool: Digital Multimeter, Backprobe Pins
04
Replace High-Pressure Fuel Pump (HPFP) or Fuel Filter

If low-pressure feed is verified but rail pressure remains under threshold, replace the camshaft-driven HPFP and follower. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).

Required Tool: Socket Set, Torx Bits, Fuel Line Disconnect Tool
05
Clear Codes and Perform Extended Drive Cycle

Clear DTC memory with scanner, start engine, check for fuel leaks, and drive for 15 minutes to verify fuel pressure monitors pass. on the Acura TLX equipped with 2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD).

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Acura TLX (P0087)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Acura TLX OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Acura TLX.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Acura TLXVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Acura TLX

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Acura TLX:

4. Acura TLX P0087 FAQs

What causes code P0087 to trigger on a Acura TLX?

On the Acura TLX (2.0L Turbo (272HP) / Type S 3.0L Turbo V6 (355HP SH-AWD)), P0087 is most frequently caused by Failing High-Pressure Fuel Pump (HPFP) or Clogged fuel filter or restricted in-tank low-pressure fuel pump (LPFP).

Where is the OBD-II port located on my Acura TLX?

On the Acura TLX, the 16-pin DLC diagnostic connector is located Driver footwell below steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Acura TLX with code P0087?

No. Low fuel pressure causes severe engine hesitation, misfires, stalling at speed, and lean detonation. Given that P0087 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.