FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
P0507JeepJeep Platform HubMaster P0507 GuideMedium Severity

P0507 on Jeep: Symptoms, Causes & DIY Fix

Official technical diagnostic wire for fault code P0507 (Idle Control System RPM Higher Than Expected - Diagnosis) specifically affecting Jeep vehicles (Grand Cherokee, Wrangler, Gladiator, Compass).

DIY Parts Estimate
$40 - $250 (DIY Throttle Relearn: $0)
Jeep OEM Direct Fit
Shop Labor Quote
$180 – $380
Based on $125/hr labor
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0507 On Another Make:
ToyotaBMWMercedes-BenzLexusFordHyundaiCadillacTeslaChevroletHondaAudiNissanJeepKiaSubaruRAMGMCVolkswagenMazdaDodgeVolvoBuickLincolnChryslerAcura

1. Symptoms of P0507 on Jeep

When the Engine Control Module (ECM/PCM) on your Jeep logs fault code P0507, drivers commonly observe:

Engine idles at 1,000+ RPM in park/neutral on Jeep (Grand Cherokee, Wrangler)
RPM surges or hunts at red lights on Jeep (Grand Cherokee, Wrangler)
Check Engine Light illuminated on Jeep (Grand Cherokee, Wrangler)

2. Most Likely Causes on Jeep

Historical warranty claims and technical repair bulletins for Jeep point to the following failure distribution:

55%
Intake manifold vacuum leak (Jeep OEM Part)
25%
Carbon buildup causing sticky electronic throttle body (Jeep OEM Part)
12%
Uncalibrated idle air volume after battery disconnect (Jeep OEM Part)
8%
Faulty PCV valve stuck open (Jeep OEM Part)

3. Step-by-Step DIY Repair Guide for Jeep

01
Check for Unmetered Vacuum Leaks

Spray brake cleaner around intake manifold gaskets; an RPM change reveals the leak location. on Jeep vehicles (Grand Cherokee, Wrangler).

02
Clean Throttle Body & Carbon Deposits

Gently clean carbon soot around throttle blade using throttle cleaner and microfiber towel. on Jeep vehicles (Grand Cherokee, Wrangler).

03
Perform Idle Air Volume Relearn Procedure

Follow vehicle-specific ignition key on/off timing sequence or use OBD scanner to reset baseline idle. on Jeep vehicles (Grand Cherokee, Wrangler).

P0507 Guides by Jeep Model

Select your specific Jeep model below for exact OBD-II DLC port locations, wiring diagrams, and engine displacement specs:

Other Common Diagnostic Codes on Jeep

Troubleshoot other high-frequency Check Engine Light fault codes reported across Jeep vehicles:

4. Jeep P0507 FAQs

What causes code P0507 to trigger on a Jeep?

On Jeep vehicles, P0507 is most frequently caused by Intake manifold vacuum leak or Carbon buildup causing sticky electronic throttle body. Factory sensor degradation or wiring harness wear near the engine bay are common factors.

Can I safely drive my Jeep with code P0507?

Driveable, but braking distance may increase slightly due to high engine idle. Given that P0507 carries a Medium severity rating on Jeep vehicles, we advise performing diagnostic scanning via the OBD-II port before extended driving.

How much does it cost to fix P0507 on a Jeep?

DIY replacement parts typically range between $40 - $250 (DIY Throttle Relearn: $0). If serviced at an authorized Jeep dealership, expect an additional $120–$250 in professional labor based on their $125/hr hourly rate.