FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
P0507VolvoVolvo XC90 HubAll Volvo P0507Medium Severity

P0507 on Volvo XC90: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0507 (Idle Control System RPM Higher Than Expected - Diagnosis) specifically on the Volvo XC90 (2020–2026, 2.0L Turbo & Supercharged B6 (295HP) / T8 Recharge Plug-In Hybrid (455HP)).

Volvo XC90
DIY Parts Estimate
$40 - $250 (DIY Throttle Relearn: $0)
XC90 OEM Fitment
Shop Labor Quote
$180 – $380
Based on $165/hr labor
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0507 On Another Volvo Model:
Volvo XC90

1. Symptoms of P0507 on Volvo XC90

When the Engine Control Module (ECM/PCM) on your Volvo XC90 (2.0L Turbo & Supercharged B6 (295HP) / T8 Recharge Plug-In Hybrid (455HP)) logs fault code P0507, drivers commonly observe:

Engine idles at 1,000+ RPM in park/neutral on Volvo XC90 (2.0L Turbo & Supercharged B6 (295HP) / T8 Recharge Plug-In Hybrid (455HP))
RPM surges or hunts at red lights on Volvo XC90 (2.0L Turbo & Supercharged B6 (295HP) / T8 Recharge Plug-In Hybrid (455HP))
Check Engine Light illuminated on Volvo XC90 (2.0L Turbo & Supercharged B6 (295HP) / T8 Recharge Plug-In Hybrid (455HP))
Volvo XC90 OBD-II Port Location
The 16-pin diagnostic connector is located Under driver steering column near footwell lamp. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Volvo XC90

Historical warranty claims and technical repair bulletins for Volvo XC90 point to the following failure distribution:

55%
Intake manifold vacuum leak (Volvo OEM Part)
25%
Carbon buildup causing sticky electronic throttle body (Volvo OEM Part)
12%
Uncalibrated idle air volume after battery disconnect (Volvo OEM Part)
8%
Faulty PCV valve stuck open (Volvo OEM Part)

3. Step-by-Step DIY Repair Guide for Volvo XC90

01
Check for Unmetered Vacuum Leaks

Spray brake cleaner around intake manifold gaskets; an RPM change reveals the leak location. on the Volvo XC90 equipped with 2.0L Turbo & Supercharged B6 (295HP) / T8 Recharge Plug-In Hybrid (455HP).

02
Clean Throttle Body & Carbon Deposits

Gently clean carbon soot around throttle blade using throttle cleaner and microfiber towel. on the Volvo XC90 equipped with 2.0L Turbo & Supercharged B6 (295HP) / T8 Recharge Plug-In Hybrid (455HP).

03
Perform Idle Air Volume Relearn Procedure

Follow vehicle-specific ignition key on/off timing sequence or use OBD scanner to reset baseline idle. on the Volvo XC90 equipped with 2.0L Turbo & Supercharged B6 (295HP) / T8 Recharge Plug-In Hybrid (455HP).

Other Common Fault Codes on Volvo XC90

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Volvo XC90:

4. Volvo XC90 P0507 FAQs

What causes code P0507 to trigger on a Volvo XC90?

On the Volvo XC90 (2.0L Turbo & Supercharged B6 (295HP) / T8 Recharge Plug-In Hybrid (455HP)), P0507 is most frequently caused by Intake manifold vacuum leak or Carbon buildup causing sticky electronic throttle body.

Where is the OBD-II port located on my Volvo XC90?

On the Volvo XC90, the 16-pin DLC diagnostic connector is located Under driver steering column near footwell lamp. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Volvo XC90 with code P0507?

Driveable, but braking distance may increase slightly due to high engine idle. Given that P0507 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.