P0152 on Toyota Crown
Factory diagnostic protocol and troubleshooting wire for fault code P0152 specifically for the Toyota Crown (2023–2026, 2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD).
1. Symptoms of P0152 on Toyota Crown
When the Engine Control Module (ECM/PCM) on your Toyota Crown (2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD) logs fault code P0152, drivers commonly observe:
2. Most Likely Causes on Toyota Crown
Historical warranty claims and technical repair bulletins for Toyota Crown point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Toyota Crown
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0152 to note engine RPM, load, and voltage when the fault triggered. on the Toyota Crown equipped with 2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD.
Inspect the electrical connector and wiring harness related to P0152 for chafing, corrosion, moisture, or pin push-out. on the Toyota Crown equipped with 2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD.
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the Toyota Crown equipped with 2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD.
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the Toyota Crown equipped with 2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD.
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the Toyota Crown equipped with 2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD.
Equipment for Diagnosing Toyota Crown (P0152)
Toyota Crown OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Toyota Crown.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Toyota Crown
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Toyota Crown:
4. Toyota Crown P0152 FAQs
What causes code P0152 to trigger on a Toyota Crown?
On the Toyota Crown (2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD), P0152 is most frequently caused by Failed Bank 2 O2 sensor or Leaking Bank 2 fuel injector.
Where is the OBD-II port located on my Toyota Crown?
On the Toyota Crown, the 16-pin DLC diagnostic connector is located Driver lower footwell beneath OBD protective lip. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Toyota Crown with code P0152?
Caution. Bank 2 reported rich. Given that P0152 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.