FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0507 on Toyota Camry Hybrid: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0507 (Idle Control System RPM Higher Than Expected - Diagnosis) specifically on the Toyota Camry Hybrid (2020–2026, 2.5L Dynamic Force 4-Cyl + Hybrid Synergy Drive (208 Net HP)).

Toyota Camry Hybrid
DIY Parts Estimate
$40 - $250 (DIY Throttle Relearn: $0)
Camry Hybrid OEM Fitment
Shop Labor Quote
$180 – $380
Based on $110/hr labor
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0507 On Another Toyota Model:
Toyota CamryToyota Camry HybridToyota Camry TRDToyota CorollaToyota RAV4Toyota HighlanderToyota Grand HighlanderToyota TacomaToyota TundraToyota 4RunnerToyota CrownToyota PriusToyota Land Cruiser

1. Symptoms of P0507 on Toyota Camry Hybrid

When the Engine Control Module (ECM/PCM) on your Toyota Camry Hybrid (2.5L Dynamic Force 4-Cyl + Hybrid Synergy Drive (208 Net HP)) logs fault code P0507, drivers commonly observe:

Engine idles at 1,000+ RPM in park/neutral on Toyota Camry Hybrid (2.5L Dynamic Force 4-Cyl + Hybrid Synergy Drive (208 Net HP))
RPM surges or hunts at red lights on Toyota Camry Hybrid (2.5L Dynamic Force 4-Cyl + Hybrid Synergy Drive (208 Net HP))
Check Engine Light illuminated on Toyota Camry Hybrid (2.5L Dynamic Force 4-Cyl + Hybrid Synergy Drive (208 Net HP))
Toyota Camry Hybrid OBD-II Port Location
The 16-pin diagnostic connector is located Under driver side dashboard next to fuse box cover. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Toyota Camry Hybrid

Historical warranty claims and technical repair bulletins for Toyota Camry Hybrid point to the following failure distribution:

55%
Intake manifold vacuum leak (Toyota OEM Part)
25%
Carbon buildup causing sticky electronic throttle body (Toyota OEM Part)
12%
Uncalibrated idle air volume after battery disconnect (Toyota OEM Part)
8%
Faulty PCV valve stuck open (Toyota OEM Part)

3. Step-by-Step DIY Repair Guide for Toyota Camry Hybrid

01
Check for Unmetered Vacuum Leaks

Spray brake cleaner around intake manifold gaskets; an RPM change reveals the leak location. on the Toyota Camry Hybrid equipped with 2.5L Dynamic Force 4-Cyl + Hybrid Synergy Drive (208 Net HP).

02
Clean Throttle Body & Carbon Deposits

Gently clean carbon soot around throttle blade using throttle cleaner and microfiber towel. on the Toyota Camry Hybrid equipped with 2.5L Dynamic Force 4-Cyl + Hybrid Synergy Drive (208 Net HP).

03
Perform Idle Air Volume Relearn Procedure

Follow vehicle-specific ignition key on/off timing sequence or use OBD scanner to reset baseline idle. on the Toyota Camry Hybrid equipped with 2.5L Dynamic Force 4-Cyl + Hybrid Synergy Drive (208 Net HP).

Other Common Fault Codes on Toyota Camry Hybrid

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Toyota Camry Hybrid:

4. Toyota Camry Hybrid P0507 FAQs

What causes code P0507 to trigger on a Toyota Camry Hybrid?

On the Toyota Camry Hybrid (2.5L Dynamic Force 4-Cyl + Hybrid Synergy Drive (208 Net HP)), P0507 is most frequently caused by Intake manifold vacuum leak or Carbon buildup causing sticky electronic throttle body.

Where is the OBD-II port located on my Toyota Camry Hybrid?

On the Toyota Camry Hybrid, the 16-pin DLC diagnostic connector is located Under driver side dashboard next to fuse box cover. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Toyota Camry Hybrid with code P0507?

Driveable, but braking distance may increase slightly due to high engine idle. Given that P0507 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.