P0353 on Tesla Model S
Factory diagnostic protocol and troubleshooting wire for fault code P0353 specifically for the Tesla Model S (2020–2026, Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s)).
1. Symptoms of P0353 on Tesla Model S
When the Engine Control Module (ECM/PCM) on your Tesla Model S (Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s)) logs fault code P0353, drivers commonly observe:
2. Most Likely Causes on Tesla Model S
Historical warranty claims and technical repair bulletins for Tesla Model S point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Tesla Model S
Confirm fault follows the coil. on the Tesla Model S equipped with Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s).
Install new ignition coil and inspect spark plug. on the Tesla Model S equipped with Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s).
Clear trouble codes and road test. on the Tesla Model S equipped with Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s).
Equipment for Diagnosing Tesla Model S (P0353)
Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)
Pre-gapped iridium spark plugs engineered to restore smooth combustion on Tesla Model S.
Magnetic Swivel Spark Plug Socket Set
360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Tesla Model S
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Tesla Model S:
4. Tesla Model S P0353 FAQs
What causes code P0353 to trigger on a Tesla Model S?
On the Tesla Model S (Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s)), P0353 is most frequently caused by Cylinder 3 ignition coil internal short/open or Harness wiring fault.
Where is the OBD-II port located on my Tesla Model S?
On the Tesla Model S, the 16-pin DLC diagnostic connector is located Under center dash / driver kick panel bulkhead. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Tesla Model S with code P0353?
No. Cylinder 3 ignition coil has failed. Given that P0353 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.