C0244 on Tesla Model S: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code C0244 (C0244: Pulse Width Modulated (PWM) Traction Control Error) specifically on the Tesla Model S (2020–2026, Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s)).
1. Symptoms of C0244 on Tesla Model S
When the Engine Control Module (ECM/PCM) on your Tesla Model S (Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s)) logs fault code C0244, drivers commonly observe:
2. Most Likely Causes on Tesla Model S
Historical warranty claims and technical repair bulletins for Tesla Model S point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Tesla Model S
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether C0244 is static or intermittent. on the Tesla Model S equipped with Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s).
Visually inspect the physical component (Electronic Brake Control Module (EBCM)), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Tesla Model S equipped with Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Tesla Model S equipped with Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Tesla Model S equipped with Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Tesla Model S equipped with Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s).
Other Common Fault Codes on Tesla Model S
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Tesla Model S:
4. Tesla Model S C0244 FAQs
What causes code C0244 to trigger on a Tesla Model S?
On the Tesla Model S (Dual Motor AWD / Tri-Motor Plaid (1,020 HP / 0-60 in 1.99s)), C0244 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Electronic Brake Control Module (EBCM)) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Tesla Model S?
On the Tesla Model S, the 16-pin DLC diagnostic connector is located Under center dash / driver kick panel bulkhead. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Tesla Model S with code C0244?
Yes, for temporary operations. However, resolve promptly to maintain optimal efficiency and prevent cascade failures. Given that C0244 carries a Moderate severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.