FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0507 on Tesla Model 3: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0507 (Idle Control System RPM Higher Than Expected - Diagnosis) specifically on the Tesla Model 3 (2020–2026, Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP)).

Tesla Model 3
DIY Parts Estimate
$40 - $250 (DIY Throttle Relearn: $0)
Model 3 OEM Fitment
Shop Labor Quote
$180 – $380
Based on $195/hr labor
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0507 On Another Tesla Model:
Tesla Model 3Tesla Model YTesla Model STesla Model XTesla Cybertruck

1. Symptoms of P0507 on Tesla Model 3

When the Engine Control Module (ECM/PCM) on your Tesla Model 3 (Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP)) logs fault code P0507, drivers commonly observe:

Engine idles at 1,000+ RPM in park/neutral on Tesla Model 3 (Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP))
RPM surges or hunts at red lights on Tesla Model 3 (Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP))
Check Engine Light illuminated on Tesla Model 3 (Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP))
Tesla Model 3 OBD-II Port Location
The 16-pin diagnostic connector is located Under driver dash (OBD-II port integrates with internal CAN gateway). Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Tesla Model 3

Historical warranty claims and technical repair bulletins for Tesla Model 3 point to the following failure distribution:

55%
Intake manifold vacuum leak (Tesla OEM Part)
25%
Carbon buildup causing sticky electronic throttle body (Tesla OEM Part)
12%
Uncalibrated idle air volume after battery disconnect (Tesla OEM Part)
8%
Faulty PCV valve stuck open (Tesla OEM Part)

3. Step-by-Step DIY Repair Guide for Tesla Model 3

01
Check for Unmetered Vacuum Leaks

Spray brake cleaner around intake manifold gaskets; an RPM change reveals the leak location. on the Tesla Model 3 equipped with Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP).

02
Clean Throttle Body & Carbon Deposits

Gently clean carbon soot around throttle blade using throttle cleaner and microfiber towel. on the Tesla Model 3 equipped with Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP).

03
Perform Idle Air Volume Relearn Procedure

Follow vehicle-specific ignition key on/off timing sequence or use OBD scanner to reset baseline idle. on the Tesla Model 3 equipped with Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP).

Other Common Fault Codes on Tesla Model 3

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Tesla Model 3:

4. Tesla Model 3 P0507 FAQs

What causes code P0507 to trigger on a Tesla Model 3?

On the Tesla Model 3 (Single Motor RWD / Dual Motor Long Range / Highland Performance AWD (510HP)), P0507 is most frequently caused by Intake manifold vacuum leak or Carbon buildup causing sticky electronic throttle body.

Where is the OBD-II port located on my Tesla Model 3?

On the Tesla Model 3, the 16-pin DLC diagnostic connector is located Under driver dash (OBD-II port integrates with internal CAN gateway). Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Tesla Model 3 with code P0507?

Driveable, but braking distance may increase slightly due to high engine idle. Given that P0507 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.