B1325 on Subaru Forester: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code B1325 (B1325: Device Power 1 Circuit Voltage Below Threshold (BCM)) specifically on the Subaru Forester (2020–2026, 2.5L Direct Injection Boxer-4 (182HP / Symmetrical AWD)).
1. Symptoms of B1325 on Subaru Forester
When the Engine Control Module (ECM/PCM) on your Subaru Forester (2.5L Direct Injection Boxer-4 (182HP / Symmetrical AWD)) logs fault code B1325, drivers commonly observe:
2. Most Likely Causes on Subaru Forester
Historical warranty claims and technical repair bulletins for Subaru Forester point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Subaru Forester
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether B1325 is static or intermittent. on the Subaru Forester equipped with 2.5L Direct Injection Boxer-4 (182HP / Symmetrical AWD).
Visually inspect the physical component (Main BCM Ground Wire), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Subaru Forester equipped with 2.5L Direct Injection Boxer-4 (182HP / Symmetrical AWD).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Subaru Forester equipped with 2.5L Direct Injection Boxer-4 (182HP / Symmetrical AWD).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Subaru Forester equipped with 2.5L Direct Injection Boxer-4 (182HP / Symmetrical AWD).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Subaru Forester equipped with 2.5L Direct Injection Boxer-4 (182HP / Symmetrical AWD).
Other Common Fault Codes on Subaru Forester
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Subaru Forester:
4. Subaru Forester B1325 FAQs
What causes code B1325 to trigger on a Subaru Forester?
On the Subaru Forester (2.5L Direct Injection Boxer-4 (182HP / Symmetrical AWD)), B1325 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Main BCM Ground Wire) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Subaru Forester?
On the Subaru Forester, the 16-pin DLC diagnostic connector is located Driver lower dash panel near hood lever. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Subaru Forester with code B1325?
Caution. Limited operation permitted only to reach a nearby repair facility or backup critical personal files. Given that B1325 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.