U0073 on 2020 RAM 2500
Technical troubleshooting wire for fault code U0073 specifically tailored for the 2020 RAM 2500. Includes wiring sensor pinouts, freeze frame PID parameters, and step-by-step diagnostic tree.
Common 2020 2500 Symptoms
- StabiliTrak / Traction / ABS / Engine warning lights lit
- Transmission shifting harshly or refusing to shift out of 2nd gear
- No communication with TCM, ABS, or BCM
- Engine may refuse to crank
Likely Root Causes on 2020 2500
- Loose or corroded ground connection on transmission or frame
- Faulty Transmission Control Module (TCM) or ABS module pulling bus down
- Poor connection at large body-to-chassis pass-through harness connector
- Aftermarket accessory (remote starter, GPS tracker, cheap OBD scanner) broadcasting invalid data
Step-by-Step Fix Protocol for 2020 RAM 2500
Connect an OBD-II scanner to the DLC port under the driver dashboard. Record engine RPM, Short Term / Long Term Fuel Trim (STFT/LTFT), and engine coolant temperature at the moment U0073 set.
Inspect the sensor connector on the 2020 2500 engine bay. Use a multimeter to verify reference voltage (5.0V / 12.0V) and ground continuity.
Replace the verified defective component using OEM or equivalent grade parts. Clear DTC U0073 and complete an EPA drive cycle to verify readiness monitors set to READY.
Equipment for Diagnosing 2020 RAM 2500 (U0073)
2020 RAM 2500 OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for 2020 RAM 2500.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.