P0125 on RAM 1500
Factory diagnostic protocol and troubleshooting wire for fault code P0125 specifically for the RAM 1500 (2020–2026, 3.0L Hurricane Twin-Turbo I6 (420HP/540HP) / 5.7L HEMI V8 eTorque / 3.6L Pentastar).
1. Symptoms of P0125 on RAM 1500
When the Engine Control Module (ECM/PCM) on your RAM 1500 (3.0L Hurricane Twin-Turbo I6 (420HP/540HP) / 5.7L HEMI V8 eTorque / 3.6L Pentastar) logs fault code P0125, drivers commonly observe:
2. Most Likely Causes on RAM 1500
Historical warranty claims and technical repair bulletins for RAM 1500 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for RAM 1500
Check that engine coolant is at full mark and no external radiator or hose leaks exist. on the RAM 1500 equipped with 3.0L Hurricane Twin-Turbo I6 (420HP/540HP) / 5.7L HEMI V8 eTorque / 3.6L Pentastar.
Start cold engine and watch ECT climb. If it plateaus below 170°F (77°C) while driving, thermostat is stuck open. on the RAM 1500 equipped with 3.0L Hurricane Twin-Turbo I6 (420HP/540HP) / 5.7L HEMI V8 eTorque / 3.6L Pentastar.
Drain 1 gallon of coolant, remove thermostat housing bolts, install new OEM temperature-rated thermostat (typically 180°F–195°F) with jiggle valve at 12 o'clock. on the RAM 1500 equipped with 3.0L Hurricane Twin-Turbo I6 (420HP/540HP) / 5.7L HEMI V8 eTorque / 3.6L Pentastar.
Fill cooling system with 50/50 prediluted coolant, run engine with spill-free funnel to purge air bubbles. on the RAM 1500 equipped with 3.0L Hurricane Twin-Turbo I6 (420HP/540HP) / 5.7L HEMI V8 eTorque / 3.6L Pentastar.
Verify scan tool Fuel System Status changes from 'Open Loop' to 'Closed Loop' within 5 minutes. on the RAM 1500 equipped with 3.0L Hurricane Twin-Turbo I6 (420HP/540HP) / 5.7L HEMI V8 eTorque / 3.6L Pentastar.
Equipment for Diagnosing RAM 1500 (P0125)
OEM Thermostat & Gasket Assembly
Direct-replacement thermostat calibrated to factory operating temperature for RAM 1500.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on RAM 1500
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the RAM 1500:
4. RAM 1500 P0125 FAQs
What causes code P0125 to trigger on a RAM 1500?
On the RAM 1500 (3.0L Hurricane Twin-Turbo I6 (420HP/540HP) / 5.7L HEMI V8 eTorque / 3.6L Pentastar), P0125 is most frequently caused by Thermostat stuck open or opening prematurely or Low engine coolant level / air pocket around ECT sensor.
Where is the OBD-II port located on my RAM 1500?
On the RAM 1500, the 16-pin DLC diagnostic connector is located Driver lower knee bolster panel to the right of parking brake. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my RAM 1500 with code P0125?
Yes, for short distances. Fuel economy will drop 15–25% as the engine remains trapped in open-loop enrichment. Given that P0125 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.