P0137 on RAM 1500 TRX
Factory diagnostic protocol and troubleshooting wire for fault code P0137 specifically for the RAM 1500 TRX (2021–2024, 6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2)).
1. Symptoms of P0137 on RAM 1500 TRX
When the Engine Control Module (ECM/PCM) on your RAM 1500 TRX (6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2)) logs fault code P0137, drivers commonly observe:
2. Most Likely Causes on RAM 1500 TRX
Historical warranty claims and technical repair bulletins for RAM 1500 TRX point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for RAM 1500 TRX
Listen for exhaust ticking or black soot around flex pipe, flanges, and sensor bungs before the catalytic converter. on the RAM 1500 TRX equipped with 6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2).
Monitor B1S2 voltage. Snap the throttle to enrich mixture; voltage should briefly spike above 0.8V. If it remains 0.0V–0.1V, sensor is defective or shorted. on the RAM 1500 TRX equipped with 6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2).
Unplug harness, remove old sensor with 7/8 socket, install replacement sensor and plug firmly. on the RAM 1500 TRX equipped with 6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2).
Clear DTCs and verify B1S2 holds steady between 0.45V and 0.75V during steady highway cruising. on the RAM 1500 TRX equipped with 6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2).
Equipment for Diagnosing RAM 1500 TRX (P0137)
RAM 1500 TRX OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for RAM 1500 TRX.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on RAM 1500 TRX
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the RAM 1500 TRX:
4. RAM 1500 TRX P0137 FAQs
What causes code P0137 to trigger on a RAM 1500 TRX?
On the RAM 1500 TRX (6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2)), P0137 is most frequently caused by Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air or Faulty downstream oxygen sensor.
Where is the OBD-II port located on my RAM 1500 TRX?
On the RAM 1500 TRX, the 16-pin DLC diagnostic connector is located Driver lower dash assembly next to hood release lever. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my RAM 1500 TRX with code P0137?
Yes. Vehicle is fully drivable, but Check Engine Light will remain illuminated. Given that P0137 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.