FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0455 on Nissan Altima: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0455 (P0455: Evaporative Emission Control System Leak Detected (Gross Leak)) specifically on the Nissan Altima (2020–2026, 2.5L 4-Cyl (188HP) / 2.0L Variable Compression Turbo (248HP)).

Nissan Altima
DIY Parts Estimate
$15 - $250 (DIY: $15 - $50)
Altima OEM Fitment
Shop Labor Quote
$180 – $380
Based on $110/hr labor
Drivability Status
Drivable (Short Trip)
Low urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0455 On Another Nissan Model:
Nissan AltimaNissan Rogue

1. Symptoms of P0455 on Nissan Altima

When the Engine Control Module (ECM/PCM) on your Nissan Altima (2.5L 4-Cyl (188HP) / 2.0L Variable Compression Turbo (248HP)) logs fault code P0455, drivers commonly observe:

Check Engine Light on on Nissan Altima (2.5L 4-Cyl (188HP) / 2.0L Variable Compression Turbo (248HP))
Gas cap loose warning message on dashboard on Nissan Altima (2.5L 4-Cyl (188HP) / 2.0L Variable Compression Turbo (248HP))
Slight fuel vapor odor near rear of vehicle on Nissan Altima (2.5L 4-Cyl (188HP) / 2.0L Variable Compression Turbo (248HP))
Nissan Altima OBD-II Port Location
The 16-pin diagnostic connector is located Under driver side dashboard to the right of hood release. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Nissan Altima

Historical warranty claims and technical repair bulletins for Nissan Altima point to the following failure distribution:

55%
Missing, loose, or cracked gas cap seal (Nissan OEM Part)
25%
Faulty EVAP purge control solenoid (Nissan OEM Part)
12%
Stuck open EVAP vent valve (Nissan OEM Part)
8%
Cracked EVAP charcoal canister vapor hose (Nissan OEM Part)

3. Step-by-Step DIY Repair Guide for Nissan Altima

01
Inspect and Tighten the Gas Cap

Remove gas cap, inspect rubber O-ring for cracks, tighten until it clicks 3 times. on the Nissan Altima equipped with 2.5L 4-Cyl (188HP) / 2.0L Variable Compression Turbo (248HP).

Required Tool: None
02
Replace Gas Cap with OEM Replacement

If the cap rubber is dried or cracked, replace with genuine OEM cap ($15). on the Nissan Altima equipped with 2.5L 4-Cyl (188HP) / 2.0L Variable Compression Turbo (248HP).

Required Tool: New OEM Gas Cap
03
Test EVAP Purge Solenoid Under Hood

Disconnect electrical plug and vacuum hose. Apply 12V; verify valve seals tight when unpowered. on the Nissan Altima equipped with 2.5L 4-Cyl (188HP) / 2.0L Variable Compression Turbo (248HP).

Required Tool: 12V Probe, Vacuum Pump
04
Inspect EVAP Canister Vent Valve Near Gas Tank

Check vent valve for road salt corrosion or spider nest clogs. on the Nissan Altima equipped with 2.5L 4-Cyl (188HP) / 2.0L Variable Compression Turbo (248HP).

Required Tool: Flashlight, Jack Stands
05
Smoke Test EVAP System

Pump mineral oil smoke into EVAP port to reveal any hairline cracked lines. on the Nissan Altima equipped with 2.5L 4-Cyl (188HP) / 2.0L Variable Compression Turbo (248HP).

Required Tool: EVAP Smoke Machine

Other Common Fault Codes on Nissan Altima

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Nissan Altima:

4. Nissan Altima P0455 FAQs

What causes code P0455 to trigger on a Nissan Altima?

On the Nissan Altima (2.5L 4-Cyl (188HP) / 2.0L Variable Compression Turbo (248HP)), P0455 is most frequently caused by Missing, loose, or cracked gas cap seal or Faulty EVAP purge control solenoid.

Where is the OBD-II port located on my Nissan Altima?

On the Nissan Altima, the 16-pin DLC diagnostic connector is located Under driver side dashboard to the right of hood release. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Nissan Altima with code P0455?

Yes. Completely safe to drive, but emissions test will fail. Given that P0455 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.