2018 Mazda Mazda3 Safety Recalls (4)
Under the National Traffic and Motor Vehicle Safety Act, manufacturers are required to remedy safety defects and noncompliance with federal motor vehicle safety standards free of charge. Below are the verified recall campaigns for the 2018 Mazda Mazda3.
Mazda North American Operations (Mazda) is recalling certain 2016-2018 Mazda3 vehicles. A defective windshield wiper relay may cause the windshield wipers to become inoperative, reducing the driver's visibility.
Reduced visibility while driving can increase the risk of crash.
Mazda will notify owners, and dealers will replace the front body control module with a new module which uses an improved wiper relay design, free of charge. The recall began May 7, 2019. Owners may contact Mazda customer service at 1-800-222-5500, option 4. Mazda's number for this recall is 3219D.
Mazda North American Operations (Mazda) is recalling certain 2018 Mazda3 vehicles, equipped with an incorrect exhaust valve spring. The incorrect exhaust valve spring may fail while driving, potentially causing an engine stall.
An engine stall can increase the risk of a crash.
Mazda will notify owners, and dealers will inspect the engines and replace any incorrect exhaust valve springs, free of charge. The recall is expected to begin January 20, 2018. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 1717K.
Mazda North American Operations (Mazda) is recalling certain 2018 Mazda3, Mazda6, 2019 CX-3, 2018-2019 MX-5, CX-5, CX-9, and 2019-2020 Mazda2 vehicles. The impeller inside the low-pressure fuel pump may crack and deform, potentially causing the fuel pump to fail.
Fuel pump failure may cause an engine stall, increasing the risk of a crash.
Dealers will replace the fuel pumps, free of charge. Owner notification letters were mailed July 18, 2022. Owners may contact Mazda customer service at 1-800-222-5500 Option 4. Mazda's number for this recall is 5321K.
Mazda North American Operations (Mazda) is recalling certain 2014-2018 Mazda3 and 2016-2021 CX-3 vehicles. The rearview camera image may not display properly by showing a flickering or distorted image.
A rearview camera that does not display properly can reduce the driver's rear view, increasing the risk of a crash or injury.
Dealers will inspect and replace the rearview camera, as necessary. In addition, dealers will install a wiring harness fastening seal. All repairs will be performed free of charge. Interim notification letters, notifying owners of the safety risk, were mailed September 13, 2023. Final owner letters for affected models and model years in the states of CT, MA, MD, NJ, NY, PA and VA were mailed August 14, 2024. The remaining owner notification letters will be mailed at a future date, anticipated on or before May 1, 2025. Owners may contact Mazda customer service at 1-800-222-5500, Option 6. Mazda's number for this recall is 6023G.
Does your 2018 Mazda3 have incomplete recalls?
Safety recalls apply to specific VIN numbers. You can check the complete 17-character VIN on the federal NHTSA portal to verify if previous owners have had these free repairs completed.
Tools for Diagnosing the 2018 Mazda Mazda3
Reads & clears all DTC codes including ABS, SRS, TPMS. Live sensor data with freeze frames. Works on all 1996+ vehicles.
Tests 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
Affiliate Disclosure: MazicBay participates in the Amazon Associates Program. We may earn a commission from qualifying purchases at no extra cost to you. Recommendations are based on vehicle compatibility data and editorial review.