P0304 on Lexus GX: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0304 (P0304: Cylinder 4 Misfire Detected) specifically on the Lexus GX (2020–2026, 3.4L Twin-Turbo V6 (V35A-FTS GX 550 349HP) / 4.6L V8 (GX 460)).
1. Symptoms of P0304 on Lexus GX
When the Engine Control Module (ECM/PCM) on your Lexus GX (3.4L Twin-Turbo V6 (V35A-FTS GX 550 349HP) / 4.6L V8 (GX 460)) logs fault code P0304, drivers commonly observe:
2. Most Likely Causes on Lexus GX
Historical warranty claims and technical repair bulletins for Lexus GX point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Lexus GX
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0304 is static or intermittent. on the Lexus GX equipped with 3.4L Twin-Turbo V6 (V35A-FTS GX 550 349HP) / 4.6L V8 (GX 460).
Visually inspect the physical component (Cylinder 4 Spark Plug / Wiring), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Lexus GX equipped with 3.4L Twin-Turbo V6 (V35A-FTS GX 550 349HP) / 4.6L V8 (GX 460).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Lexus GX equipped with 3.4L Twin-Turbo V6 (V35A-FTS GX 550 349HP) / 4.6L V8 (GX 460).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Lexus GX equipped with 3.4L Twin-Turbo V6 (V35A-FTS GX 550 349HP) / 4.6L V8 (GX 460).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Lexus GX equipped with 3.4L Twin-Turbo V6 (V35A-FTS GX 550 349HP) / 4.6L V8 (GX 460).
Other Common Fault Codes on Lexus GX
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Lexus GX:
4. Lexus GX P0304 FAQs
What causes code P0304 to trigger on a Lexus GX?
On the Lexus GX (3.4L Twin-Turbo V6 (V35A-FTS GX 550 349HP) / 4.6L V8 (GX 460)), P0304 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Cylinder 4 Spark Plug / Wiring) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Lexus GX?
On the Lexus GX, the 16-pin DLC diagnostic connector is located Driver side lower knee panel above dead pedal. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Lexus GX with code P0304?
No. Immediate shutdown / repair required to prevent permanent hardware destruction or total system lockup. Given that P0304 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.