P0744 on Lexus ES
Factory diagnostic protocol and troubleshooting wire for fault code P0744 specifically for the Lexus ES (2020–2026, 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD).
1. Symptoms of P0744 on Lexus ES
When the Engine Control Module (ECM/PCM) on your Lexus ES (3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD) logs fault code P0744, drivers commonly observe:
2. Most Likely Causes on Lexus ES
Historical warranty claims and technical repair bulletins for Lexus ES point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Lexus ES
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0744 to note engine RPM, load, and voltage when the fault triggered. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Inspect the electrical connector and wiring harness related to P0744 for chafing, corrosion, moisture, or pin push-out. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Equipment for Diagnosing Lexus ES (P0744)
Lexus ES OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Lexus ES.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Lexus ES
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Lexus ES:
4. Lexus ES P0744 FAQs
What causes code P0744 to trigger on a Lexus ES?
On the Lexus ES (3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD), P0744 is most frequently caused by Intermittent TCC solenoid failure or Contaminated transmission fluid.
Where is the OBD-II port located on my Lexus ES?
On the Lexus ES, the 16-pin DLC diagnostic connector is located Directly under driver dash, left side of steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Lexus ES with code P0744?
Yes. Intermittent lockup slippage. Given that P0744 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.