P0335 on Lexus ES: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0335 (P0335: Crankshaft Position Sensor A Circuit Malfunction) specifically on the Lexus ES (2020–2026, 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD).
1. Symptoms of P0335 on Lexus ES
When the Engine Control Module (ECM/PCM) on your Lexus ES (3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD) logs fault code P0335, drivers commonly observe:
2. Most Likely Causes on Lexus ES
Historical warranty claims and technical repair bulletins for Lexus ES point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Lexus ES
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0335 is static or intermittent. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Visually inspect the physical component (Crankshaft Position (CKP) Sensor), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Other Common Fault Codes on Lexus ES
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Lexus ES:
4. Lexus ES P0335 FAQs
What causes code P0335 to trigger on a Lexus ES?
On the Lexus ES (3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD), P0335 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Crankshaft Position (CKP) Sensor) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Lexus ES?
On the Lexus ES, the 16-pin DLC diagnostic connector is located Directly under driver dash, left side of steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Lexus ES with code P0335?
No. Immediate shutdown / repair required to prevent permanent hardware destruction or total system lockup. Given that P0335 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.