P0674 on Hyundai Palisade: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0674 (P0674: Cylinder 4 Glow Plug Circuit Malfunction) specifically on the Hyundai Palisade (2020–2026, 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque)).
1. Symptoms of P0674 on Hyundai Palisade
When the Engine Control Module (ECM/PCM) on your Hyundai Palisade (3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque)) logs fault code P0674, drivers commonly observe:
2. Most Likely Causes on Hyundai Palisade
Historical warranty claims and technical repair bulletins for Hyundai Palisade point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Hyundai Palisade
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0674 is static or intermittent. on the Hyundai Palisade equipped with 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque).
Visually inspect the physical component (Cylinder 4 Glow Plug), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Hyundai Palisade equipped with 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Hyundai Palisade equipped with 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Hyundai Palisade equipped with 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Hyundai Palisade equipped with 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque).
Other Common Fault Codes on Hyundai Palisade
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Hyundai Palisade:
4. Hyundai Palisade P0674 FAQs
What causes code P0674 to trigger on a Hyundai Palisade?
On the Hyundai Palisade (3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque)), P0674 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Cylinder 4 Glow Plug) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Hyundai Palisade?
On the Hyundai Palisade, the 16-pin DLC diagnostic connector is located Under driver side dashboard kick panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Hyundai Palisade with code P0674?
Yes, for temporary operations. However, resolve promptly to maintain optimal efficiency and prevent cascade failures. Given that P0674 carries a Moderate severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.