P0335 on Hyundai Palisade: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0335 (P0335: Crankshaft Position Sensor A Circuit Malfunction) specifically on the Hyundai Palisade (2020–2026, 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque)).
1. Symptoms of P0335 on Hyundai Palisade
When the Engine Control Module (ECM/PCM) on your Hyundai Palisade (3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque)) logs fault code P0335, drivers commonly observe:
2. Most Likely Causes on Hyundai Palisade
Historical warranty claims and technical repair bulletins for Hyundai Palisade point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Hyundai Palisade
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0335 is static or intermittent. on the Hyundai Palisade equipped with 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque).
Visually inspect the physical component (Crankshaft Position (CKP) Sensor), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Hyundai Palisade equipped with 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Hyundai Palisade equipped with 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Hyundai Palisade equipped with 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Hyundai Palisade equipped with 3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque).
Other Common Fault Codes on Hyundai Palisade
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Hyundai Palisade:
4. Hyundai Palisade P0335 FAQs
What causes code P0335 to trigger on a Hyundai Palisade?
On the Hyundai Palisade (3.8L V6 GDI (Lambda II 291HP / 262 lb-ft torque)), P0335 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Crankshaft Position (CKP) Sensor) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Hyundai Palisade?
On the Hyundai Palisade, the 16-pin DLC diagnostic connector is located Under driver side dashboard kick panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Hyundai Palisade with code P0335?
No. Immediate shutdown / repair required to prevent permanent hardware destruction or total system lockup. Given that P0335 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.