FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0507 on Hyundai Ioniq 5: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0507 (Idle Control System RPM Higher Than Expected - Diagnosis) specifically on the Hyundai Ioniq 5 (2022–2026, Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP)).

Hyundai Ioniq 5
DIY Parts Estimate
$40 - $250 (DIY Throttle Relearn: $0)
Ioniq 5 OEM Fitment
Shop Labor Quote
$180 – $380
Based on $105/hr labor
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0507 On Another Hyundai Model:
Hyundai ElantraHyundai SonataHyundai TucsonHyundai Santa FeHyundai PalisadeHyundai Ioniq 5

1. Symptoms of P0507 on Hyundai Ioniq 5

When the Engine Control Module (ECM/PCM) on your Hyundai Ioniq 5 (Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP)) logs fault code P0507, drivers commonly observe:

Engine idles at 1,000+ RPM in park/neutral on Hyundai Ioniq 5 (Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP))
RPM surges or hunts at red lights on Hyundai Ioniq 5 (Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP))
Check Engine Light illuminated on Hyundai Ioniq 5 (Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP))
Hyundai Ioniq 5 OBD-II Port Location
The 16-pin diagnostic connector is located Driver side lower dash bezel near steering base. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Hyundai Ioniq 5

Historical warranty claims and technical repair bulletins for Hyundai Ioniq 5 point to the following failure distribution:

55%
Intake manifold vacuum leak (Hyundai OEM Part)
25%
Carbon buildup causing sticky electronic throttle body (Hyundai OEM Part)
12%
Uncalibrated idle air volume after battery disconnect (Hyundai OEM Part)
8%
Faulty PCV valve stuck open (Hyundai OEM Part)

3. Step-by-Step DIY Repair Guide for Hyundai Ioniq 5

01
Check for Unmetered Vacuum Leaks

Spray brake cleaner around intake manifold gaskets; an RPM change reveals the leak location. on the Hyundai Ioniq 5 equipped with Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP).

02
Clean Throttle Body & Carbon Deposits

Gently clean carbon soot around throttle blade using throttle cleaner and microfiber towel. on the Hyundai Ioniq 5 equipped with Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP).

03
Perform Idle Air Volume Relearn Procedure

Follow vehicle-specific ignition key on/off timing sequence or use OBD scanner to reset baseline idle. on the Hyundai Ioniq 5 equipped with Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP).

Other Common Fault Codes on Hyundai Ioniq 5

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Hyundai Ioniq 5:

4. Hyundai Ioniq 5 P0507 FAQs

What causes code P0507 to trigger on a Hyundai Ioniq 5?

On the Hyundai Ioniq 5 (Dual Motor AWD (320HP) / Single Motor RWD (225HP) / Ioniq 5 N (641HP)), P0507 is most frequently caused by Intake manifold vacuum leak or Carbon buildup causing sticky electronic throttle body.

Where is the OBD-II port located on my Hyundai Ioniq 5?

On the Hyundai Ioniq 5, the 16-pin DLC diagnostic connector is located Driver side lower dash bezel near steering base. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Hyundai Ioniq 5 with code P0507?

Driveable, but braking distance may increase slightly due to high engine idle. Given that P0507 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.