P0137 on GMC Yukon
Factory diagnostic protocol and troubleshooting wire for fault code P0137 specifically for the GMC Yukon (2021–2026, 5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax).
1. Symptoms of P0137 on GMC Yukon
When the Engine Control Module (ECM/PCM) on your GMC Yukon (5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax) logs fault code P0137, drivers commonly observe:
2. Most Likely Causes on GMC Yukon
Historical warranty claims and technical repair bulletins for GMC Yukon point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for GMC Yukon
Listen for exhaust ticking or black soot around flex pipe, flanges, and sensor bungs before the catalytic converter. on the GMC Yukon equipped with 5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax.
Monitor B1S2 voltage. Snap the throttle to enrich mixture; voltage should briefly spike above 0.8V. If it remains 0.0V–0.1V, sensor is defective or shorted. on the GMC Yukon equipped with 5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax.
Unplug harness, remove old sensor with 7/8 socket, install replacement sensor and plug firmly. on the GMC Yukon equipped with 5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax.
Clear DTCs and verify B1S2 holds steady between 0.45V and 0.75V during steady highway cruising. on the GMC Yukon equipped with 5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax.
Equipment for Diagnosing GMC Yukon (P0137)
GMC Yukon OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for GMC Yukon.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on GMC Yukon
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the GMC Yukon:
4. GMC Yukon P0137 FAQs
What causes code P0137 to trigger on a GMC Yukon?
On the GMC Yukon (5.3L / 6.2L V8 (Denali Ultimate) / 3.0L Duramax), P0137 is most frequently caused by Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air or Faulty downstream oxygen sensor.
Where is the OBD-II port located on my GMC Yukon?
On the GMC Yukon, the 16-pin DLC diagnostic connector is located Driver side under steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my GMC Yukon with code P0137?
Yes. Vehicle is fully drivable, but Check Engine Light will remain illuminated. Given that P0137 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.