2018 GMC Yukon Safety Recalls (3)
Under the National Traffic and Motor Vehicle Safety Act, manufacturers are required to remedy safety defects and noncompliance with federal motor vehicle safety standards free of charge. Below are the verified recall campaigns for the 2018 GMC Yukon.
General Motors LLC (GM) is recalling certain 2018 Cadillac Escalade, Chevrolet Silverado 1500 and Tahoe, GMC Sierra 1500 and Yukon vehicles equipped with either a 5.3L or 6.2L V8 engine. The output of the mechanical vacuum pump can decrease over time, decreasing the amount of vacuum/power brake assist.
A decrease in brake assist can increase the brake pedal effort and distance required to stop the vehicle, increasing the risk of a crash.
GM will notify owners, and dealers will reprogram the Electronic Brake Control Module, free of charge. The recall began November 11, 2020. Owners may contact GM customer service at 1-866-522-9559, Cadillac customer service at 1-800-458-8006 or Chevrolet customer service at 1-800-630-2438. GM's number for this recall is N202300860.
General Motors LLC (GM) is recalling certain 2015-2017 Cadillac Escalade, 2014-2018 Chevrolet Silverado, GMC Sierra, 2015-2018 Chevrolet Suburban, Tahoe, GMC Yukon vehicles. The amount of vacuum created by the vacuum pump may decrease over time.
As the vacuum level drops, the brake assist decreases, increasing braking effort, extending the distance required to stop the vehicle, thereby increasing the risk of a crash.
GM will notify owners, and dealers will reprogram the Electronic Brake Control Module, free of charge. The recall began October 8, 2019. Owners may contact Chevrolet customer service at 1-800-630-2438, Cadillac customer service at 1-800-458-8006 or GMC customer service at 1-800-462-8782. GM's number for this recall is N192268490.
General Motors LLC (GM) is recalling certain 2015-2020 Chevrolet Suburban, Tahoe, and GMC Yukon, and 2014-2018 Chevrolet Silverado 1500 and GMC Sierra 1500 vehicles equipped with a 5.3-liter engine, a 3.08-ratio rear axle and four-wheel drive. If a wheel-speed sensor fails, while the vehicle is traveling between 41 and 60 mph in four-wheel or automatic mode, the Electronic-Brake Control Module (EBCM) software may activate the driveline-protection system.
Unintended activation of the driveline-protection system will cause unintended braking on the wheel on the opposite side of the failed sensor, causing the vehicle to pull to one side unexpectedly, increasing the risk of a crash.
GM will notify owners, and dealers will reprogram the EBCM, free of charge. The recall began December 11, 2019. Owners may contact Chevrolet customer service at 1-800-630-2438 or GMC customer service at 1-800-462-8782. GM's number for this recall is N192261050.
Does your 2018 Yukon have incomplete recalls?
Safety recalls apply to specific VIN numbers. You can check the complete 17-character VIN on the federal NHTSA portal to verify if previous owners have had these free repairs completed.
Tools for Diagnosing the 2018 GMC Yukon
Reads & clears all DTC codes including ABS, SRS, TPMS. Live sensor data with freeze frames. Works on all 1996+ vehicles.
Tests 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
Affiliate Disclosure: MazicBay participates in the Amazon Associates Program. We may earn a commission from qualifying purchases at no extra cost to you. Recommendations are based on vehicle compatibility data and editorial review.