B1325 on Ford Maverick: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code B1325 (B1325: Device Power 1 Circuit Voltage Below Threshold (BCM)) specifically on the Ford Maverick (2022–2026, 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP)).
1. Symptoms of B1325 on Ford Maverick
When the Engine Control Module (ECM/PCM) on your Ford Maverick (2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP)) logs fault code B1325, drivers commonly observe:
2. Most Likely Causes on Ford Maverick
Historical warranty claims and technical repair bulletins for Ford Maverick point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Ford Maverick
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether B1325 is static or intermittent. on the Ford Maverick equipped with 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP).
Visually inspect the physical component (Main BCM Ground Wire), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Ford Maverick equipped with 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Ford Maverick equipped with 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Ford Maverick equipped with 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Ford Maverick equipped with 2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP).
Other Common Fault Codes on Ford Maverick
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Ford Maverick:
4. Ford Maverick B1325 FAQs
What causes code B1325 to trigger on a Ford Maverick?
On the Ford Maverick (2.5L Hybrid FWD/AWD (191HP) / 2.0L EcoBoost Turbo AWD (250HP)), B1325 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Main BCM Ground Wire) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Ford Maverick?
On the Ford Maverick, the 16-pin DLC diagnostic connector is located Under driver side steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Ford Maverick with code B1325?
Caution. Limited operation permitted only to reach a nearby repair facility or backup critical personal files. Given that B1325 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.