U0104 on Ford Explorer
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Ford Explorer (2020–2026, 2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP)).
1. Symptoms of U0104 on Ford Explorer
When the Engine Control Module (ECM/PCM) on your Ford Explorer (2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP)) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Ford Explorer
Historical warranty claims and technical repair bulletins for Ford Explorer point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Ford Explorer
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Ford Explorer equipped with 2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP).
Verify power feed to radar sensor. on the Ford Explorer equipped with 2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP).
Execute optical/radar alignment procedure if bumper was removed. on the Ford Explorer equipped with 2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP).
Clear DTCs and test cruise on highway. on the Ford Explorer equipped with 2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP).
Equipment for Diagnosing Ford Explorer (U0104)
Ford Explorer OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Ford Explorer.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Ford Explorer
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Ford Explorer:
4. Ford Explorer U0104 FAQs
What causes code U0104 to trigger on a Ford Explorer?
On the Ford Explorer (2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP)), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Ford Explorer?
On the Ford Explorer, the 16-pin DLC diagnostic connector is located Lower steering column dash trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Ford Explorer with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.