P0122 on Ford Explorer: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0122 (P0122: Throttle Position Sensor (TPS) Circuit Low Input) specifically on the Ford Explorer (2020–2026, 2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP)).
1. Symptoms of P0122 on Ford Explorer
When the Engine Control Module (ECM/PCM) on your Ford Explorer (2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP)) logs fault code P0122, drivers commonly observe:
2. Most Likely Causes on Ford Explorer
Historical warranty claims and technical repair bulletins for Ford Explorer point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Ford Explorer
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0122 is static or intermittent. on the Ford Explorer equipped with 2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP).
Visually inspect the physical component (TPS Potentiometer), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Ford Explorer equipped with 2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Ford Explorer equipped with 2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Ford Explorer equipped with 2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Ford Explorer equipped with 2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP).
Other Common Fault Codes on Ford Explorer
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Ford Explorer:
4. Ford Explorer P0122 FAQs
What causes code P0122 to trigger on a Ford Explorer?
On the Ford Explorer (2.3L EcoBoost 4-Cyl (300HP) / 3.0L Twin-Turbo EcoBoost V6 (ST 400HP)), P0122 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (TPS Potentiometer) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Ford Explorer?
On the Ford Explorer, the 16-pin DLC diagnostic connector is located Lower steering column dash trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Ford Explorer with code P0122?
Caution. Limited operation permitted only to reach a nearby repair facility or backup critical personal files. Given that P0122 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.