P0135 on Ford Bronco: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0135 (O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 1)) specifically on the Ford Bronco (2021–2026, 2.3L EcoBoost (300HP) / 2.7L Twin-Turbo V6 (330HP) / 3.0L Raptor (418HP)).
1. Symptoms of P0135 on Ford Bronco
When the Engine Control Module (ECM/PCM) on your Ford Bronco (2.3L EcoBoost (300HP) / 2.7L Twin-Turbo V6 (330HP) / 3.0L Raptor (418HP)) logs fault code P0135, drivers commonly observe:
2. Most Likely Causes on Ford Bronco
Historical warranty claims and technical repair bulletins for Ford Bronco point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Ford Bronco
Locate the under-hood fuse box and test the O2 sensor heater fuse with a multimeter or test light. on the Ford Bronco equipped with 2.3L EcoBoost (300HP) / 2.7L Twin-Turbo V6 (330HP) / 3.0L Raptor (418HP).
Unplug the Bank 1 Sensor 1 connector and test resistance between the two heater pins (typically 3 to 15 ohms). on the Ford Bronco equipped with 2.3L EcoBoost (300HP) / 2.7L Twin-Turbo V6 (330HP) / 3.0L Raptor (418HP).
Use an O2 sensor socket wrench to remove the old sensor from the exhaust manifold and install an OEM-spec replacement with anti-seize on the threads. on the Ford Bronco equipped with 2.3L EcoBoost (300HP) / 2.7L Twin-Turbo V6 (330HP) / 3.0L Raptor (418HP).
Other Common Fault Codes on Ford Bronco
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Ford Bronco:
4. Ford Bronco P0135 FAQs
What causes code P0135 to trigger on a Ford Bronco?
On the Ford Bronco (2.3L EcoBoost (300HP) / 2.7L Twin-Turbo V6 (330HP) / 3.0L Raptor (418HP)), P0135 is most frequently caused by Burnt-out internal heating element in upstream oxygen sensor or Blown O2 sensor heater fuse.
Where is the OBD-II port located on my Ford Bronco?
On the Ford Bronco, the 16-pin DLC diagnostic connector is located Beneath steering wheel lower shroud. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Ford Bronco with code P0135?
Yes, vehicle is safe to drive, but will stay in open-loop mode longer upon startup. Given that P0135 carries a Low to Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.